2005 td4 exhaust sections

Hello all , need some advice on my td4,s exhaust ,been under and had a look , from the downpipe with a flexi joint to a flange , then the next section that has the cat , with a silencer in line just behind (thats split) then the pipe goes to the rear silencer , thats also goosed , it seems to be all in one section , that is the cat with one silencer (middle section) can i get the replacement parts , eg , if the pipe is cut after the cat ,thanks ian

This is the whole lot
FREELANDER TD4 CENTRE REAR EXHAUST INC CAT 2.0 TD 00-07 | eBay

Go to exhaust-a-fix in Darlington, there replace just the sections you need replacing......I got my smaller back box done there....they done a good job.

Thanks for the info

Hello all , update on this topic , exhaust a fix were not to helpfull on the phone , so tried my local factors , £234 for the 2 sections with the cat , not too forthcoming when i mentioned decat mods , looked on ebay , cheapest was what nodge put up , any way next day one of mates put this strait up on his phone IMASAF td4 centre exhaust section 270608461030 £109 free postage from GERMANY , so i took the plunge and after 9 days it arived today , RESULT just what i needed , as my cat is still intact , and clamp fitting , i now have to carefully measure and cut the old pipe to fit , the back box cost £36 , so i saved £90 QUID

Fitted this section last sat , very pleased with the quality and fit , for late td4s if your cat is intact , RECOMENDED

Good work dude,

I may have to do something similar soon

Any chance of a picture of the join/cut?

Cheers

And just for interest really, what is the Outside Diameter (OD) of the pipe if you can measure it? Thanks

Hi , the cut with a angle grinder was made where the deflecter plate starts , that was cut off first , took a couple of goes of grinding until the pipes joined , theres not a great deal of play where the rear of the pipe passes through the sub frame/drive shaft area , the rear box is smaller than the oem part , a bit more ground clearence the (OD) is 7 and 3/8 of a inch , I used the 65 mm clamps that came with the section .

glad you did not buy it of Mr exhaust they do not last long

Can any one help me find the correct oem part number for the mid section on a late model td4 as despite searching endless sites i cant work it out?

Cheers