Scot and Ben

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
2nd coat of por15...
20200222_215234.jpg
 
Finished exams early and took the advice of @Shimsteriom and partook in a bit of r&r with the angle grinder :D

After a few measurements and using a length of threaded bar it's time to make the first cut :eek:
20200228_163217.jpg


Removed the old plate that had been bodged on

20200228_172413.jpg


20200228_172405.jpg

Then offered the new dumb iron
20200228_172925.jpg


Plenty of cut off disks in stock:D

20200228_173510.jpg


Tomorrow I'll get the welder out and tidy the chassis up and do a better job of replacing the thinner steel and weld the new dumb iron on then do the other side :D
 
Finished exams early and took the advice of @Shimsteriom and partook in a bit of r&r with the angle grinder :D

After a few measurements and using a length of threaded bar it's time to make the first cut :eek:
View attachment 201787

Removed the old plate that had been bodged on

View attachment 201789

View attachment 201790
Then offered the new dumb iron View attachment 201791

Plenty of cut off disks in stock:D

View attachment 201794

Tomorrow I'll get the welder out and tidy the chassis up and do a better job of replacing the thinner steel and weld the new dumb iron on then do the other side :D
Why are those discs disintegrating like that? Too much pressure?
 
Finished exams early and took the advice of @Shimsteriom and partook in a bit of r&r with the angle grinder :D

After a few measurements and using a length of threaded bar it's time to make the first cut :eek:
View attachment 201787

Removed the old plate that had been bodged on

View attachment 201789

View attachment 201790
Then offered the new dumb iron View attachment 201791

Plenty of cut off disks in stock:D

View attachment 201794

Tomorrow I'll get the welder out and tidy the chassis up and do a better job of replacing the thinner steel and weld the new dumb iron on then do the other side :D

The state of they discs lol good to see its finally underway. :)
 
Back
Top