Cranking no start

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Kevinsv

Member
Posts
20
Location
Darlington County Durham UK
Hi can anybody help me my freelander 2 2008 cranking but no start fault codes p2564-37 p0340-00 p0380-00 p0642-00 they are all circuit A and state permanent do you think it needs a ECM thanks any help suggestions
 
I would say do some diagnosis using a multimeter and wiring diagram first before condemning ecm

when did the fault occur and what has happened to the car prior to the fault?
 
I'd be checking for a wiring fault, that is affecting the 3 items (MAP sensor, Cam sensor and glow plug circuit) that those codes refer too.
Was there any warning to this fault? Or did it just not start one day?
 
I would say do some diagnosis using a multimeter and wiring diagram first before condemning ecm

when did the fault occur and what has happened to the car prior to the fault?
Hi have tried to find a good wire diagram Haynes manual even paid on line to download one but none show the 5volt A diagram good when I got it it was not working they said it was injections I have cleaned and tested them 2 had blocked stream and only one glow plug worked fitted new Bosch glow plugs I put new diesel filter in and used a hand pump to pull fuel through filter one thing happen I forgot to put return pipe in filter tried to start and no fuel came out
 
Can you recommend a good wiring diagram please
Thanks for that do you know by any chance where I can get one of theses pipe connectors it's had its top saw off thanks for any help new and trying to find my way round site
 

Attachments

  • IMG_20200210_213517.jpg
    IMG_20200210_213517.jpg
    176.5 KB · Views: 154
Can’t see clearly where that pipe is from - which part of the engine is it from?

check the powers and grounds for the ecm as first port of call. The 5 volt circuits are all separate in the car (not sure on internal to ecu) but a faulty sensor could pull the voltage down and cause the P0642 to be set. Check the cam sensor and turbo actuator and map sensor for 5 volt supply

if you send me your email address via a private message I can send you a pdf of the wiring diagram for the ecm
 
Back
Top