Gipsyjoe
Member
- Posts
- 10
- Location
- Southampton
Hi there I have just got a landrover discovery 2 on a 54 plate the bit point is very low can it be adjusted at all
Clutch
- Thread starter Gipsyjoe
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 66,408
- Location
- The Wooly Witch
hiya
it’s a discovery 2 , I’m afraid I don’t know about those , plus op has a thread here as well
https://www.landyzone.co.uk/land-rover/clutch.356733/
- Posts
- 66,408
- Location
- The Wooly Witch
hiya
it’s a discovery 2 , I’m afraid I don’t know about those , plus op has a thread here as well
https://www.landyzone.co.uk/land-rover/clutch.356733/
Who shall we call ?
Henry_b
Think outside, no box required.
- Posts
- 15,351
- Location
- somewhere else
Air in the hydraulic system..
On the other hand a high bite point is a worn clutch..
bleed it..
On the other hand a high bite point is a worn clutch..
bleed it..
Gipsyjoe
Member
- Posts
- 10
- Location
- Southampton
Is that hard to do
brianconwy
Well-Known Member
- Posts
- 1,112
- Location
- conwy, north wales
Its just a bleed nipple like the brakes. i didn't get a good result from just bleeding ours from below. Used an oil can with brake fluid in it and pressured the system from above the master cylinder.
