Another wiper problem.

mick the builder · Apr 15, 2019

Since finishing the rebuild, I put the wipers on in the sticky out position before switching them on. Just as well because instead of going up the screen from rest, they would have gone across the bonnet . I have to position the blades in the 12o'clock position for the to wipe the scree and this is where they stop. All I removed in the build was the arms and the nuts off the front of the spindles which I pushed back in the bulkhead prior to spraying . Any thoughts?

Al2O3 · Apr 15, 2019

mick the builder said:
Since finishing the rebuild, I put the wipers on in the sticky out position before switching them on. Just as well because instead of going up the screen from rest, they would have gone across the bonnet . I have to position the blades in the 12o'clock position for the to wipe the scree and this is where they stop. All I removed in the build was the arms and the nuts off the front of the spindles which I pushed back in the bulkhead prior to spraying . Any thoughts?

Possibly the park switch has coincidentally packed in?

TorsionBhudda · Apr 16, 2019

The wheel boxes for the arms are upside down! I had same issue when I did my rebuild

mick the builder · Apr 16, 2019

TorsionBhudda said:
The wheel boxes for the arms are upside down! I had same issue when I did my rebuild

Thanks mate. Edit, i didnt remove the wheel boxs from the sleeve, just undone the nuts on the baulkhead and pushed them inside while i was spraying then pulled them out and put the nuts back.???

Another wiper problem.

mick the builder

Well-Known Member

Al2O3

Well-Known Member

TorsionBhudda

Well-Known Member

mick the builder

Well-Known Member

Similar threads