Engine oil breather to air intake adaptor

Hi there,

Does anyone know where I can find the adaptor part to the air filter for an oil breather hose? At the moment I have it dangling in the engine bay pumping fumes through holes into the cab...

Thank you!

If that is your filter housing then it is the small spigot sticking out at 90 degrees.

I used one of these when I swapped out my old tin can for a sealed housing when I fitted a snorkel.



It's a plastic skin fitting for boats, used for bilge pumps etc,.

https://www.force4.co.uk/plastic-skin-fitting.html

Just punch a hole through the intake pipe and fit with a smear of SIKA flex to seal it up and job done.

Sounds good enough to me, I haven't got the landy around at the moment, any chance you remember the size required?

Thank you so much, these forums are amazing!

Lej said:

Sounds good enough to me, I haven't got the landy around at the moment, any chance you remember the size required?

Thank you so much, these forums are amazing!

Click to expand...

measure the ID of your breathing hose i think its about 19 mm but dont hold me on this
also have a look into installing a decent catch can ....this can help the intercooler and intake manifold coking (even if the EGR is blanked or not )