Chequer plate rear load liner

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Dudeface

New Member
Posts
7
Location
Newmarket
Hey everyone,
Was going to rivet it in but wirried about leaky rusty water holes, any other ideas? Mastic maybe?
Would be very appreciative of any suggestions, thanks!
Dan
 
Hey everyone,
Was going to rivet it in but wirried about leaky rusty water holes, any other ideas? Mastic maybe?
Would be very appreciative of any suggestions, thanks!
Dan
Are you trying to cover holes that have appeared where the floor touches the the floor cross members?
 
Absolutely!
If you decide to rivet it in, make sure you buy aluminium rivets so they don't react with the aluminium floor and load liner. Treat the rivets on the outside with dinitrol or similar.
Or, you could just bond it in. It's not as though it's going to be under any load against the adhesive! Make sure you get a good bond around the edges to prevent moisture getting between the two.
Are you planning on carrying a lot of rough, heavy stuff?
 
If you decide to rivet it in, make sure you buy aluminium rivets so they don't react with the aluminium floor and load liner. Treat the rivets on the outside with dinitrol or similar.
Or, you could just bond it in. It's not as though it's going to be under any load against the adhesive! Make sure you get a good bond around the edges to prevent moisture getting between the two.
Are you planning on carrying a lot of rough, heavy stuff?
I carry a full load of loose wood twice a week so reckon it should be fine with the adhesive, I just like the idea of doing it the strongest way, but yes I think you’re right, it won’t go anywhere!
 
I done my mates with Sikaflex & I use it on boats every week for all sorts of jobs but don't expect to remove
it easily lol
You could also paint it with raptor paint & tint it to the same colour as your motor ;)
 
I done my mates with Sikaflex & I use it on boats every week for all sorts of jobs but don't expect to remove
it easily lol
You could also paint it with raptor paint & tint it to the same colour as your motor ;)
yep use it on my boats to stick down ali checker, its quite for giving on damp surface will stick and cure.
 
3, 18 ft open hull.
one with diesel in board, 2 with out board.
fish the river dee estuary with trammel nets, flounder, grey mullet,winter time odd cod.
 
Could you use rivnuts and stainless bolts rather than rivets? You can unbolt it then to check underneath?

I drilled 2 holes in my tub so the water can drain out, mines a pick up :/
 
I replaced the linear with 3mm chequer plate. I used the same holes to rivet it in and used tiger seal. Ten years later it is still going strong.
 
Back
Top