P38A hub nut

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

ukadamwest

Well-Known Member
Posts
2,990
Location
Surrey
What a b**ch.

1m long breaker bar and it still won't shift.

Anyone any ideas.

No I don't have a scaffold pole
 
You ****. I actually got up to check the thread direction.

And yes I did undo the indent

Then you either need stronger arms/ a longer bar / a scaffold pole.Have you tried an extension piece, between the socket and breaker bar, sat on an axle stand to allow you to apply the torque to the nut without twisting the socket on the nut?

Cheers
 
Yup. tried that I'm getting about 15 degrees of curve on the bar before I run out of torque. I'm not small either.
 
I figure on the scaffold pole too. But not a scooby where i will get a good length of pole, stop snickering at the back, on a sunday.

Going to go and get my compressor tomorrow and see if the impact gun will get it
 
Pop over to Gravesend in Kent and I will give you a length of scaffold pole you can take away and play to your hearts content or I csan stick my 380nm gun on it
 
Get someone to give the nut a good clout with a hammer as you're trying to undo it. Often, the shock is enough to crack it.
 
Back
Top