Diesel leak

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Larahausp1

Member
Posts
88
Location
Halesowen
Just niticed diesel leaking from front right by the egr valve. Any ideas of how big a job it is. Looks like its coming from fuel lines above turbo hose. Mainly on 1st start up
 
Last edited:
Click in the ‘reply’ box. At the bottom right is a button labelled ‘Upload a File’.
20171201_092637.jpg
 
Just niticed diesel leaking from front right by the egr valve. Any ideas of how big a job it is. Looks like its coming from fuel lines above turbo hose. Mainly on 1st start up

Easy job for a competent DIYer. As long as the parts to fix it can be found. I think hose PN: WJH104061 would probably fit ok, if it's the elbow hose leaking. If it's a straight hose, then any auto-factors would do it. It could also be the pipe coupler, which again would come from an auto-factors. You'll also need some worm clips.
 
Easy job for a competent DIYer. As long as the parts to fix it can be found. I think hose PN: WJH104061 would probably fit ok, if it's the elbow hose leaking. If it's a straight hose, then any auto-factors would do it. It could also be the pipe coupler, which again would come from an auto-factors. You'll also need some worm clips.
Screenshot_20171201-135832.png
 
These ones
No. Worm clips, or worm drive clips, are the type that use a screw thread to tighten a steel band. They are commonly called Jubilee clips, but that is just one manufacturer. Like this.
Screenshot_20171201-150325.png
I prefer Norma worm drive clips myself, although they are hard to get.
 
The clips that are fitted to the fuel thermo valve already are re-useable, they can be open with a thin bladed screw driver, then squeezed back together with some pliers, it maybe that the hose as flared on the end and needs cutting back a little, this is a judgment you need to make as you on there on the job, view it and make your decision then, at the same time you can see what size the clip is.

These vales are also on the R40 but under the rear f the car photo 2 below, the hoses tend to leak at the ends because of flaring.
 

Attachments

  • SDC15440.JPG
    SDC15440.JPG
    271.9 KB · Views: 130
  • 041.JPG
    041.JPG
    348.3 KB · Views: 129
The clips that are fitted to the fuel thermo valve already are re-useable, they can be open with a thin bladed screw driver, then squeezed back together with some pliers, it maybe that the hose as flared on the end and needs cutting back a little, this is a judgment you need to make as you on there on the job, view it and make your decision then, at the same time you can see what size the clip is.

These vales are also on the R40 but under the rear f the car photo 2 below, the hoses tend to leak at the ends because of flaring.
Photo 1 looks similar to my photo so will check all those. But not sure on photo 2 mine is a 53 plate 2.0Td4
 
Photo 1 looks similar to my photo so will check all those. But not sure on photo 2 mine is a 53 plate 2.0Td4

Photo two is of the same vale but on a Rover 75 diesel, which uses the same thermo valve it is situated at the rear of the R75 photo is just an example, so no need to worry there.
 
Back
Top