Disco 2 Is this an not fail? Photo inside.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

ldrego

Active Member
Posts
394
Location
Edinburgh
could someone in the know tell me if this is an mot fail? It is on the rear leg of my discovery 2. I am assuming it will need to be repaired at some point if not immediately but if so, could it be plated?
 
Ahh the picture.
 

Attachments

  • image.jpeg
    image.jpeg
    832.9 KB · Views: 264
I don't mind attacking it later with an angle grinder / steel rotary wire combo but just now, need it just to get through the mot.
 
This would take a good thrashing like to make a hole in that. I do need to investigate it further but not this week if you understand. My chassis protection stuff is just not working. I must have put so much man hours into it but just not getting there whatsoever. I will post up my box section repairs shortly and hopefully you can give me a little advise on whether they should pass. I was told at the previous mot place that these sections under the door sills were not structural hence gave them a shot with my welder.
 
i suppose it depends on the m.o.t tester,if
it passes i think it will be down as an advisory.
i hope it passes for you mate.
 
Hoping too. I would just like for once to get a clear run on the mot with this car. I was going to post the welding that I had done however the camera cannot focus that close.
 
Back
Top