Hertfordshire Lanes?????

I dont think it's the kind of thing anyone is likely to have lying around, but I would pay £50 to get a secondhand one by Tuesday. Can collect.

stutab said:

I would say yes. Might give you problems if you don't

Click to expand...

must say your avatar pic is very good

jamesmartin said:

must say your avatar pic is very good

Click to expand...

Cheers. Not bad for a phone. I was pulled off ploughing to fetch some seed and walking back to the tractor thought that is a nice picture.

Whaddon last sunday
Whaddon 4x4 punch event: http://www.youtube.com/watch?v=tUxzb4ADMJs

All the guys that went said was a good day!!

Looks like there's still a few people still on this thread I remember. Anything much been happening?

Hey Kris

How's things??

Mile tree was postponed to this Saturday jai

Doh I've gotta shoot to lee valley Sat pickup some bits. Sunday i'm getting the trialer ready to be trailered so I can get on with the darn thing! Need it finished now it's starting to pee or orff!

I know that feeling Jai. You got much left to do on it?

Not really it's he welding on the chassis rear spring hangers that's annoying so will get that sorted while on a ramp then I can do the bodywork bolt it back together and use the damn thing!

Anyone going

Farrar I just got in. I saw it on face book I was half tempted.

You going???

Yea im going to take a wonder up there for 8. Not in landy though as its not on the road at the moment.

Farrar said:

Yea im going to take a wonder up there for 8. Not in landy though as its not on the road at the moment.

Click to expand...

Same as that! Just seems everything I do leads into another problem atm. Tyres were wearing thin so put four 2nd hand tyres on. One of which had a puncture with the rear wheels off I noticed the disc were in pretty bad nick. Go to buy new disc and pads, turns out my 110 shouldn't have discs. So have to go home take an old one off to measure up for which disk I need. Just tried fitting the new ones and there isn't enough room in the calliper for the disk and new pads, Wtf! Think I'm cursed

Pic of he back axle would help can advise ideally the hub drive member

Are the pistons returning fully?

Can do photos tomorrow morning. Stutab, I measured the two pads and the disk at 49mm and the gap in the calliper ignoring the pistons at 48mm. Somethings not right.

Sounds like you got RRC disc's. If I get chance tomorrow I will measures mine.

I'm assuming there are different thicknesses of pads. If I can find some down the shop first thing, with the same profile and a bit thinner I'm sorted. If not its out with the grinder.