What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
52848897-9552-64b0.jpg
Started project forward facing seats.

As you will see in picture...i hope, they wont fit to edge of tub. B n q i found 3mm by 30mm millrd steel lengths. Currently cutting and bending under heat to create a strong l shaped bracket which will fit to top of inner edge of tub and flat to wheel arch and bolted in. Seat bolts to that and wheel arch.

There is about 4inches of the seat overlapping the wheel arch but ok for occasional use. 3point seat belts too.
 

Attachments

  • uploadfromtaptalk1331402017736.jpg
    uploadfromtaptalk1331402017736.jpg
    73.8 KB · Views: 144
Fitted an air filter, temporary straps for now. A mate is going to fab me a custom stainless bracket...

And took off the cable tie holding up the fuel filter and bodged up a bracket, not too good but again a stainless one is on the way.

I'm particularly pleased with the colour coded stripe on the air pipe and the fact it's no longer inhaling all kind o' ****e.

dsc_0184.jpg

dsc_0182.jpg

dsc_0183.jpg
 
replaced the wheelbearing that left me stranded at the side of the a518 yesterday. i had to replace the stub axle too.

then topped up the paint on my hubs, and started prep for painting the front end of it ready for the indoor 4x4 show.
 
Back
Top