What have you done to your Landie today.

nothing - but got the 40 MOT'd

Fitted the power steering pump (cheers Jamesmartin)..mobile again..got cig lighter fixed so can use gps...painted rear x member and rear tub...super.

storm99 said:

Fitted the power steering pump (cheers Jamesmartin)..mobile again..got cig lighter fixed so can use gps...painted rear x member and rear tub...super.

Click to expand...

Nice one boss

storm99 said:

Fitted the power steering pump (cheers Jamesmartin)..mobile again..got cig lighter fixed so can use gps...painted rear x member and rear tub...super.

Click to expand...

After noon sun; how did you make out with your mom's clutch job?

£580 at Toyota...has to have it done there otherwise the warranty is void...even though this isn't covered by the warranty...fkd if you do, fkd if you dont.

Removed the shovel from the offside wing and the pick axe head from the nearside wing so as I will have some place to rest tools if I have to take the head off!

Freed off the nearside caliper with a BIG hammer and a chisel so I can move the beast with the tractor without skidding the grass up on the field when I tow it to a better place for fixing.

Started to clear the garage out and put Landy spares and tools where I can find them !

New vitron seal in IP, new timing belt (last one only done 4k and was badly delaminated!) no more leaky squeaky!

Finally sorted front prop out.
Bought it yesterday, spent about 5 hours fixing and fitting it, as it needed a new UJ - old broken one didnt want to come out, and new one didnt want to go in! - and then the bolts on the transfer box flange were so battered from it failing, I needed to grind off the ends of the bolts to get new nuts on.

But its sorted..... for now........

Sy

Removed the front section of headlining from my 110 CSW (removed the rest a couple of weeks ago) and stuck thermal / acoustic matting over most of the exposed metal panels in preparation for Lasalle Headlining kit when it arrives in a few weeks.

Unfortunately I cannot refit the rear view mirror which is a bit of a bugger.

Neil
1996 Defender 110 CSW 300Tdi

Put new springs on the rear suspension - sits level now, not lopsided.

Fitted new seals to the front bulkhead vent flaps - hopefully have less cold drafts next winter.ound:

Put the re sealed Disco steering box on the 90...

Steam cleaned the engine bay and underneath, then a nice thick coat of wax oil

Any one in the Essex area know of any green lanes quarries etc I can have a play in

Towed it to a different spot for repair with the Dexta so we can cut the grass from underneath it

got it dirty laning

Went through aldershot high street in first on the over run

pop pop pop pop pop.

not to mine but did a bit of weldering on a mates 90 bloody hell how that fuel tank did'nt fall out
being as its a 4.2 v8 might have something to do with it it dont stay above half full for very long

Made it look like a 1970s era Dr Who space ship by trimming out the underside of the roof in silver coated acoustic foam.
And temporarily fitted new Buffalo Board on the roofrack - to be finished with countersunk machine screws after I've done the sunroof and healing in a few weeks.

Removed the starter motor and the battery from my TD5 Disco to have them checked.

changed transfer and gear box oils