BTW my repairs worked out slightly cheaper than a delete kit EXCEPT I bought a brand new rear ARB because it was cheap, rude not to.

No cat at all, bought it ages ago, but could not get teh old one off, then life happened

Just listed some D2 bits, need to clear the garage.

In Worcester, rear ACE anti roll bar, tatty, ram ok but starting to rust. Will be going to tip if no one has it. Would suit someone wanting a spare to rebuild. I managed to get a brand new one, when I hose converted. Collection only, need to clear garage.

Will be collect, in Worcester, unused decat pipe, just never got round to fitting, also had to have new cat for an MOT. So offers, need to clear the garage.

No, rough, contitec, genuine. Will run a bit longer before I buy anti squeak spray.

Obvious, new belt, new tensioner

No point suggesting the obvious two. Any other ideas, air con on off makes little difference.

I don't know. But mine would be a prime target over most D2

None available anymore

No but I want them safe

Are there any? Want better protection.

No one around here will do it. Someone suggested a place in Lampeter, which is a lovely drive cross country

I gave up in the end, had just the rear quarter done

would be cheaper to hire a few hitmen

56 quid for a genuine one, I need to find a good aftermarket non Dayco squeaky thing. My old genuine was ok until last year when the squeaks started. Six years old

Drivers seat, the bit screwed to the seat base, mine shattered today while removing to get to CD changer. Alpaca beige. Anyone have one? For now will be a go at heat welding

Not by much though

6 or 7 years ago

Block mods about £60 to £100 for a small engineering company. Hoses, mine were about £20 each, my repair was less than a removal kit.