Ok so I purchased a used injection pump for my 2.5na I used the lock up tool so I didn’t have to take front of motor apart. I set the pump bled the filter and the little screw on top of pump crack it and nothing to the injectors. I looked in the inspection plate and the pump pulley is turning...

Can someone please tell me a cheap calibration tool I can get for the height ride sensor? My icarsoft scanner won’t let me program the new height ride sensors and air shocks. I replaced both front air shocks and height ride sensors and it keeps dropping and saying air ride suspension inactive.

So I installed a used injection pump on my 2.5na diesel. I have 30psi fuel going into the pump and nothing to the injectors. Belt is turning the pump I can see through the inspection plate. I’m guessing I got screwed and got a bad used pump?

Ok this is my next problem. The fuel gauge stays on 3/4 tank at all times but the low fuel light comes on when I drain tank. Now would the sender be bad and low fuel light still work? I don’t want to buy a sender if it’s the gauge. How would I be sure?

Does anyone have a pic of there oil temp sender in the oil filter housing or in the sump I have a 1985 2.5na motor

Anyone know what adapter I need to fit the oil temp sender into the filter housing?

I need some help. I installed led turn signals and they all blink at same time when signaling left or right. I put 2 load resistors across the green power wire in the rear ones and they still blink toghether did I do something wrong?

Anyone have any idea what these wires go to? My book don’t show thEm they are on a 1986 2.5 they are in the engine compartment from the bulkhead. First pic is a 2 wire harness with a brown/yellow female and brown/white male Second pic is a single male green/looks like light brown

Hello on my 1986 2.5na I have an oil temp gauge that’s hooked up but under the hood I see no oil temp sending unit or any wires besides the oil pressure sending unit. Can someone tell me what color the wire should be from firewall and where should the sender be?

Hello new member here I really could some help. I’m swapping an injection pump on a 1986 2.5na 110. I purchased a used pump and the special locking tool so I don’t have to do the timing. What’s the procedure Just swap the pumps and I’ll be good? I’m doing this in my driveway with little...