Hi Clutch has always been bottom of the floor but have noticed that recently it has got worse. Considering changing the master cylinder to see if that makes any difference as when I felt the master cylinder push rod it felt as though it had some oil on it. If I install an OE one will I need to...

Hi all Does anyone know anywhere decent near Wolverhampton where I can get my wheel alignment done? Thanks Jon

Hi All Recently had the N/S front driveshaft changed and now have a noticeable vibration up to about 30mph. I'm a little concerned this could cause other damage. Thoughts, advice, experienced greatly appreciated as always. Thanks

Hi All Had the belt snap on me on the way home Friday evening. Is it a fairly straight forward procedure to replace it and roughly how long does it take? Many thanks.

Morning All MOT says CV boot deteriorated, is there an easy way of changing it or is it a pig of a job. Cheers

Hi All Looking for a decent tyre for a FL1 2006 TD4 that will give good mileage, road use only. Not after budget tyres and pref something that will 30k miles or there abouts. Cheers

Hi All Freelander 1 2006 TD4 130,000 miles. What oil do you suggest for an oil change on that mileage 5/40 or 10/40? Thanks

Hi everyone Freelander 1 TD4 2006 Bought a new fuel pressure harness as I currently have to spray the connector with contact spray every couple of days. Actual sensor was replaced last year but not the harness. Seen articles on here but just wondered if anyone knows the pin numbers I need to...

Hi all Anyone know of a good place near Wolverhampton where I can get rear brakes and drums etc replaced? Cheers

Chaps & Chapesses Simple question but I doubt a simple answer. I think I may have one or maybe more suspect injectors. Symptoms - lots of white smoke on startup and v lumpy for 10 seconds or so followed by a misfire from 1500rpm onwards. It's always had a bit of a misfire around 2000rpm but...

Evening all... Brimmed the 2006 FL1 TD4, ran it for 470 miles, filled back up 56.47ltr. does 38mpg average sound about right? Cheers

Hi All Freelander 1 TD4 2006. Always started a bit rough in the morning with a cloud of white smoke, but after 5 - 10 seconds everything is good, I assumed maybe a sticking injector, but I can put up with that. Recently though I'm getting a misfire and a clanking nose around 2k to 2.5k rpm. It...

Hi All Does anyone know of a good LR independent in the Wolverhampton area who could change a clutch. Clutch is pretty much on the floor and feels heavy. Would it be worth changing the master first and the clutch fluid to see if it makes any difference? Thanks in advance

Hi Can anyone advise if I need to remove the engine mount to remove the high pressure fuel pump or can I get away without doing this. Thanks in advance

Hi Can anyone advise if I need to remove the engine mount to remove the high pressure fuel pump or can I get away without doing this. Thanks in advance