SOunds very much like a prob i had, Bob weights and springs had come loose and when i checked for the spring action it became even looser. The pics show how much the rotor arm moved and the shaft also went up and down, just make sure it's sitting correctly. You've also got the same set up as i...

Here's my 3.9 so you should see a difference

Hope she's a beaut !!! GENUINE only, even if it means delaying the jacket for a while :)

Hey up Fred, Sorry matey, dont know much about the sunroof, only that my manual tells me to go to a specialist. (it's a crap manual though) Have you checked to make sure there's no blockages etc?

Looks the biz !!! Bit closer to you matey................ Lochgilphead Forest Drive Two Choices - Page 18 - Land Rover UK Forums

great news fred, well dont matey

Ahh right, Understand about the filter but that's about it. Bit too techy for me,I'll just be sticking to 11mpg by the look of it. Although someone did mention if i get a straight through pipe and do away with the middle silencer i might save on fuel???

Also got a Classic on LPG single point and i reckon i get 11 mpg. When you say do some tweaking............what are you going to do if i may ask. I know my system has an adjusting screw on the vaporiser and one on the air pipe that goes into the plenum chamber. Are these the things that need to...

They dont rub now as i adjusted the steering stops to stop it happening. Don't know much about the Air suspension, but i do know you'll need to be carefull if your offroading it as you might damage it.Most people opt to get rid and convert to coils for offroading as it's less hassel and more...

Here's my Classic. I got 2" higher springs put on, heavy duty Scorpion racing ones. Then managed to put 265/75/16 Insa Turbo Dakar muds on it without them rubbing. Shocks are still standard at the moment so there's not great articulation but it gives me lots of fun. Anti roll bars removed front...

Bloody landie fever it is he he he

I've just got intot his malarky since last september but it's amazing how much info you pick up if your prepared to do the searching, places like this and a few other forums i'm on are invaluable and save ye a fortune on garage bills. ;)

I take it you have a 3.5 EFI? As you have a cold start injector. Most times it's just a case of TLC for the car as people before you may have neglected it for a while. DOnt know if it's true but after a few starts and stops and runs too and fro, your ECU will start to listen better to the...

I had running problems when i first got my RRC, I changed the CTS also and it did improve the running. I also made sure Leads, Dizzy cap, rotor arm where replaced with GENUINE parts as it's amazing how much a difference poor pattern parts have on your car. Here's what your after RPi Land Range...

Here's a few pics taken from my weekend down in cannock with BOFA4x4.co.uk I dont have upgraded shocks on at the moment hence the wheel nicely up in the air.I have 2"lifted springs, Diff guard on the front.Insa Turbo Dakars 265/75/16 and the only thing i had to do was adjust the steering stops...

Feel for ye matey, really do. Hope it can be skimmed and it's not too bad (if it's not been skimmed already):(

Just bought a set of tyres off Craddocks, Not recieved them yet but they gave me problems for 2 days about postage, If i was buying again, i'd try paddockspares, and they are slightly cheaper also. I've got a good set of Classic alloys, but i'm not sure if i should put my 265/75/16 on the...

Will do, although some problems i had later on was due to poor pattern parts being used by the previous owner. Breather pipes etc were in very poor condition as was leads and coil. CTS was also replaced and the final thing that made it running great now, was infact a poor rotor arm. Got a...

There's already a mark on it as i had to strip it down to reset the bob weights and springs when i first got it. Just wondering if it was worth a go as it might run even better.

Will this TIP with the timing work on a 3.9 EFI engine? Mines is running pretty well now but when it idles i can hear a very slight noise that may be a small misfire. Just wondering if i should leave it or try this method. Cheers DC