Will be collect, in Worcester, unused decat pipe, just never got round to fitting, also had to have new cat for an MOT. So offers, need to clear the garage.

No, rough, contitec, genuine. Will run a bit longer before I buy anti squeak spray.

Obvious, new belt, new tensioner

No point suggesting the obvious two. Any other ideas, air con on off makes little difference.

I don't know. But mine would be a prime target over most D2

None available anymore

No but I want them safe

Are there any? Want better protection.

No one around here will do it. Someone suggested a place in Lampeter, which is a lovely drive cross country

I gave up in the end, had just the rear quarter done

would be cheaper to hire a few hitmen

56 quid for a genuine one, I need to find a good aftermarket non Dayco squeaky thing. My old genuine was ok until last year when the squeaks started. Six years old

Drivers seat, the bit screwed to the seat base, mine shattered today while removing to get to CD changer. Alpaca beige. Anyone have one? For now will be a go at heat welding

Not by much though

6 or 7 years ago

Block mods about £60 to £100 for a small engineering company. Hoses, mine were about £20 each, my repair was less than a removal kit.

I hydraulic hose converted mine

keep it

i think I will go with them and see what it is like in a couple of years, I am currently saving about £9k a year because WFH

Started by thinking of new galvanised chassis. OK, they have given it a good look over and I only need the rear quarter replaced, despite a welded ARB bracket. Should be doing it late next week, or the week after. And a few other bits, then a good waxoyling.