Are you running on chip oil/bio? Have you checked the lift pump is working?

Dunno...but I've got lots of 6mm tubing and a valve with a 6mm pushfit on it, well...4 valves actually. The good old eas emergency inflate kit. Is non of that any good for kermie ?

Got that stuff at mine if you need to borrow.

12 nuts, standard m8 nuts if you lose any.

It's easier with the manifold off for sure. The long one is a fiddle but if you reach round over? the fip with your right hand guiding the pipe with your left it's doable. Had to do that twice on mine.

It is 3.2mm inside diameter. The same tubeing is used from the inlet manifold to the map sensor(on the fuel filter housing) that one rots too. Its a bit of a bugger to do with the inlet manifold on, I take it off but in this weather and with your limited knowledge? Some of the manifold nuts are...

S Super rare and worth ££££££ ?

Sorry, only just seen the reply. Doors, bulkhead and seatbox disconnected and me and a mate removed the 110 van body. Wheels were off so it was lift-shunt-lift shunt etc until it reached the balance point at the rear of the chassis and was then tipped up on its end and shuffled out the way. The...

Ooppss..

I did a search and wammers post came up. I've got 4 wheel tc I think, 2001 dhse so it's no good for me.

Still giving Stirling service 3 yrs later, Ta mate!

Plastic ones can break yes. When I first got my 38 I removed the pump which had a plastic impeller to fit one with a steel impeller. The plastic one was fine but when I removed it there was bits of plastic impeller inside the recess from a previous breakage that they hadn't cleared out. Can't...

Got given this, I'm later D. Good for a spare or useless to me. Don't know if it's even working.

I fitted the uprated reg on your advice and had no issues. If @P38Seb finds it low then it can be replaced without stressing over the tensioner again without removing the alternator because I did it. A mirror helped to see the bolt heads otherwise straightforward. I can't find the link for...

Diesel, cos I stalked his posts!.

Same are used on defender arches .

My centre interior light works but one of the map light buttons has broke off. Got hold of a good casing so going to swop the bits around to make a good one today. The plastic has Austin (British Leyland ) moulded on the reverse. Wonder what car that was on out of the Austin range?.

I was gentle but it still broke. I blamed a ham fisted previous owner who must have cracked the alloy and I just finished it off.

That's strange. Both the mobile guys and the depot in Shrewsbury fitted new top trims . Had to wait 2 weeks for Shrewsbury though as the screen came in a week after my complaint of the shoddy fitted first one but another week for the new trim. 2 new screens, both with trims.

Yeah, they don't supply them. Luckily I had a full set.