1. S

    Retrofitting interior upgrade

    Thats the type of info I'm after! Thanks.
  2. S

    Retrofitting interior upgrade

    I'm looking at something a long the lines of this but it states fits 2007 onwards. With my defender being a 94 I'm unsure if it will fit??? http://www.ebay.co.uk/itm/Land-Rover-Defender-110-PUMA-seats-full-leather-interior-kit-front-middle-rear-/261468443480?hash=item3ce0bbd358:g:2yIAAOSwI~VTzWjC
  3. S

    Retrofitting interior upgrade

    I'm only looking to fit Land Rover interiors albeit nice full leather seats etc.
  4. S

    Retrofitting interior upgrade

    Looking to really tart up my 94 Defender 110 300Tdi over the course of the next 12 months and that includes looking at replacing the interior. When it comes to seats is it possible to retro fit any late defender interior???
  5. S

    Crankcase pressure.....

    Well just finished fitting new turbo and my Landy now drives like a Landy should. Boosting just shy of 1bar and pulling really strong I am extremely happy. I don't think it's ever been right since I bought it but at last it is sorted. New radiator, intercooler and oil cooler being fitted...
  6. S

    Crankcase pressure.....

    I was a little concerned about the exp tank hence I shot it in the video, yet I've been told it isn't an issue. It is also not using any water and it is crystal clear. I know my idle needs upping a little as it is very lumpy and slow hence I think the vibration of the cap at idle is a lot to do...
  7. S

    Crankcase pressure.....

    Video below. Notice when I increase throttle the cap remains still. http://vid135.photobucket.com/albums/q135/RIngrey/EVO videos/IMG_1151.MOV.mp4
  8. S

    Crankcase pressure.....

    Landy drives like a normally aspirated vehicle only boosting to 0.4 bar, lots of oil in boost pipes, lots of oil around cyclone breather. Possible causes may simply be that oil seals have gone in turbo either through age/mileage and a faulty actuator. However, I want to cover all avenues before...
  9. S

    Crankcase pressure.....

    I have done exactly what you have mentioned above. I am attempting to upload a video to show you the outcome of the test. The cap does rattle a little but it certainly doesn't get blown off. If you give it a little throttle then it stays completely still so not sure if the rattle is crankcase...
  10. S

    Crankcase pressure.....

    Can someone tell me how to tell if the crankcase pressure is correct or too high on a 300tdi???
  11. S

    300tdi turbo replacement - Is there a how to guide on LZ???

    As above. Is there a turbo replacement guide on this site? Preferably a pictorial guide.
  12. S

    Rough cost for replacement sunroof seal???

    I have finally identified the source of my water leak in the cabin. The water is getting in via a split sunroof seal and working its way along the roof lining and down the inside of the drivers door into the footwell. What sort of cost would be involved to supply and refit new sunroof seal?
  13. S

    Advice on respray, Dumfries and Galloway

    Just remember that a good paint job is all in the prep. Don't bother with metallics and always maintain your wet edge. Painting is a fine art; plenty can paint but not many can paint well. If I was you I'd buy a cheap panel from your local scrappy and practice prepping and painting on that...
  14. S

    Advice on respray, Dumfries and Galloway

    I manage a paint shop and I would advise you against prepping your vehicle and then expecting someone else to then spray it on your behalf. Save the extra pennies and get the job done properly. I don't want to dwell too much on this but potentially you are opening up a can of worms. If the...
  15. S

    Rear end knock.......

    Do you have any pictures please?
  16. S

    Rear end knock.......

    1/2 inch.
  17. S

    Rear end knock.......

    I've been trying to identify a rear end knock on my 110 that occurs when mounting/dismounting kerbs for example. Everything would appear nice and tight apart from the lower shock mount. There is about a 1/2 gap between the mount and the bush. Is this correct as I would have thought the bush...
  18. S

    How easy and how to do it???

    How easy is it to change the piece of body work that runs below the rear window line and around to the safari door?
  19. S

    How much???

    Go on??? I took the feed for the boost pipe from the turbo to actuator feed pipe.