Are you in the right gear when using HDC

had the same problem on what was once my Freelander 1 the daughters for the last 7 years ,had to weld a section of a cut off of a box spanner (did not want to damage plastic the box spanner was the same physical shape )the right size and weld it to a old 1/2" drive socket so a extension and...

try running a ground wire from relay connection (BP) to eliminate the ECU SIGNAL,if this cures the problem then you will have to trace the BP wire back to the ECU.but also check relay connection on fuse box for tight fitment,this can be checked with a male spade connector or it, equivalent type...

I assume you have replaced the fuel filter to eliminate low fuel delivery and checked the relay contacts etc on the dud relay to confirm it is the relay.have you checked for 12volt signal at relay and the ground is good

you may have it already and did the kit come with new phosphorous bronze bushes and seals for the throttle shaft

just out of curiosity where did you get your strip from

try

Try

bit like the Talbot horizon leaving the factory with rust ,not many of them around these days

just buy a Dacia Duster if you like the look ( I doubt it will survive as long as the Freelander)

I would check the front rear drivers side subframe bolt to see if its still attached to the chassis,why land rover used 14mm bolt passing through a 17mm sub frame mount hole into a 18mm chassis spacing tube into a 14mm square anchor nut held by a flimsy cage .on my 2002 model the nut can be...

On my daughters (was mine ,who would of thought in the 6 years of ownership and hardly any maintenance or cleaning would result in the work I had to do from prop shaft bearing lower suspension arms ,sway bar linkages rear break pipe's rear brake cylinders and hose as the rust had corroded the...

try

is the dash light a LED as it would be polarity sensitive and stop the one side from working

may help

TRY

as mentioned before what is the switch part no

try https://www.landyzone.co.uk/land-rover/series-2a-wiring.380658/

what is the number of the ignition switch you are trying to use ,and is it the diesel version and not a petrol version info please

do not know the switch ref or if it's the correct one but try as below