Yes I know it's a thread from the dead but has anyone fitted these I'm thinking it will tidy up the boot a bit a respray would be best but I like a bit of chrome

That will save me a ton of work cheers will have a look today

I am going to fit a 12v socket in the boot so need to get power to it. Plan A was run a cable from battery via a fuse but I can't get past the bulk head easily. Plan B take the positive from fuse box under under the drivers seat what is the dangers of killing something? I'm planning on...

Replaced the choc block connector that sorted the broken wire causing hot start problems I fitted last year with a water proof connector. It now no longer looks like such a bodge. Fitted new exhaust tips old ones where rusted and looked awful. This lead me to realise I really should replace...

I take it your old one wasn't working or did you want an upgrade for a newer system. As a rough idea how much less than fitting a full new sysyem I'd you don't mind me asking?

Bit of a trek from up here but thanks

Never thought about that it could be an issue

Hi where are they based?

It's an ag autogas sgi - sequential gas injection system I've had 2 people look at it one said its an old system and we didn't fit so won't touch best replace it - spent less than 5 mins looking at tiny. Second said prob electrical issue, we can look at it but might be cheaper to have a go...

My lpg system has never worked since I have had tiny. I can't see anything obviously wrong so suspect dodgy wire somewhere I need to get a decent multi meter to test them as no power. But as its an old system obviously a new system should be an upgrade has anyone done this how much of the old...

I'm not sure I prefer the balance of oval on one side RAC badge on the other. Gambling man?

I've got this RAC badge it was my grand dads I had it in a box for years recently found it again. I'm thinking of fitting it to tiny see below with and with out the backing plate. If I don't fit it to tiny I'm going to make a wooden backing plate and hang it in the house. I might hang this...

Yesterday I washed hoovered and cleaned the insides all in prep for today I taxed her and took her out for a drive first time since September. The smile on my face the whole time was embarrassing but I don't care. I forgot how vague the steering and cornering is with the wheel off centre so...

Mine where a rough silver looked like hamerite redid them in red high temp paint did the premium at the same time looks good now will see how they go

If you have an early car with white head lights the swap to black lights looks good imo

Just got tiny back with a clean mot now just need to wait till the end of the month and stick some tax on her and enjoy. Still got a few jobs to finish to get everything working and get her just the way I want her but I'm happy

Well emissions are still to high so waiting to get the codes read by the garages diagnostic kit. Hopefully this will tell me what to do next lambdas or cats or something else :( It gets better headlight adjustment isn't possible as it from a left hand drive vehicle ahhhhh new head light now...

OK just a thought. Lpg is way down the to do list need to replace an wiring plug that was left loose and melted on the exhaust then chase down the wiring fault that is stopping the whole system from powering up.

Fitted replacement brake caliper carrier so she is ready to go back for her retest. I've been thinking about high emisions could the fact tiny is fitted with lpg thus timing could have been adjusted so cause my prob?

Dumped a bottle cataclean in the tank and left to idle says 15 mins got busy working on something else so half hour look latter. Don't know if any improvement but hopefully the mot guy will see some.