Thanks Grrr thats very decent of you but quite a distance. Can someone tell me how or what gives the car its levels from side to side...is it just sensor based using an algorithm? I think I shall try swapping the valve block over just out of curiosity as I am somewhat stuck now. The rangy has...

Yes using storey wilsons. I dont have a nanocom. I dont know what a live trace is sorry.

I dont have to wait till morning it just leans when driven and is leaning when parked up in my garage. I changed the front height sensor and made up 16 blocks took all measurements and rewrote to memory. It did feel different but transmission was noisier. I changed the front sensor but it made...

The more I think about this the more I have come to realise that the car has had this issue since I bought it and hadnt really noticed until changing the airbags exasperated the issue. How do I assertain the pipes are connected corrrectly ? The lean appears to be on both front and rear and...

I dont think the pipes are crossed as they have not been altered during my ownership.The individual bags lift and drop using the software on heights. When the car is put into high mode a solonoid clicks away for a minute or 2 stopping if I open a different function. Now I do have another valve...

I have tried everything I can think of. I can get it level with software but once driven the left front and back drop lower than the right again

After waiting a while things didnt really improve. The car would go lopsided whilst driving or parking . It dumps itself down on front left.I decided to replace the sensor on front left it made some difference but didnt cure the issue. I then made up 4 sets of height adjustment blocks and took...

I had similar issues with mine and eventually traced it to the plug connector on the compressor it seemed fine and mostly worked but randomly stopped passing current. I think the copper connectors had softened with age/heat. I replaced the plugs with block connectors which cured the issue.

If it doesn't resolve itself I will try that.

Cheers guys that all makes sense. I shall take do as advised . Thank you very much.

I have the software and cable. I could leave the car for any amount of time with the old bags and it wouldnt drop in the slightest even when left for a week.Is thete a guide somewhere on how to check /adjust using the software? Thanks

The bags were very tired looking but never leaked at all. Innitially the car felt much better.Would it be a good idea to replace the height sensors too ? I dont know how to check height calibration nor make any adjustments.

The mechanic did it with 2 trolley jacks.Its never done the dance before

I had all 4 airbags changed yesterday as they all looked perished. Went for a good run after getting them changed , 1st impressions were good but after a little while the suspension started feeling hard and crashy .When car pulls up to a stop the front goes up and down a few times before...

Gone for the scorpions to play it safe .Blackcircles £348 for a set of 4 delivered which seems very keen to me. Theres still lots of tread on 3 of them but checked the datecodes and theyre all 2008 tyres so think they best get binned.Not going to do the airbags myself chickening out of that...

Cheers Wammers have ordered from there. Whats the opinion of General grabber xt tyres ? Can get a set of 4 on ebay for £365. My car runs on 255.65.16s

Took rangey for mot last night. It passed but the inspector pointed out canvas showing on pretty much all the air bags. Where should I buy replacements from...theres a set on ebay£235 delivered..same as oe buy made by britpart, are they ok or should I buy Proper Dunlop? If so where from? I also...

Thanks lol. Its not as bad as it sounds just the occasional little overnight squirt..hardly a nappy full

Mine still takes a small pee at night on the floor.

I looked through my written guide and can only find 3 grease nipples listed. It also says use a handgun not air but I only have air. Will this be an issue.