Hi Glenn321, it was a factory 3.5L V8 but has a had a 3.9L V8 EFI since before I bought it. I still have it if you are interested and I can pm you more details if you wish?

Hi donp38, I replied to your pm on 31st March with info and pictures, did you receive it ok?

sorry should read 2017 for new crossmember :rolleyes:

I have a 1983 V8 unfinished project if you are interested? It is in Northern Ireland. Had new rear crossmember in 2019 and chassis welding around passenger footwell. Been under cover since so not sure if there are any new welding needs. Its a truck cab and I have the old doors that need bottoms...

Thanks Flossie, doubt if anyone would buy from here as viewing is bit too complicated. Will take a few pictures and put them up.

I have a 1983 110 which has been shortened to a 90 by a previous owner. Has 131k on 3.9litre EFI V8 again transplanted by a previous owner. I have completed the chassis work including new rear cross member, replaced the truck cab and installed new rear glass, insulation and head lining. New...

for keeping chickens in? or is that a Bantam Ark?

Hi pressbrake, I thought the duty cycle looked ok even with the max amps being 140. Just looked up what OCV refers to but can't work out if you are saying it is good or bad on this welder.

Yes, I know, been reading up on this on Welding - The DIY Guide and have been looking for the low amp info but not every manufacturer or reseller gives this. Could be they are not giving it because the lowest amp setting is not so good. Appreciate the feedback blue beasty, after reading the...

Hi, Can anyone please advise if the following is a good spec for an mid range welder? Sealey MIGHTYMIG170 Professional Gas/ No Gas MIG Welder Maximum Current:..........................................................................................170A Wire Capacity...

If you post the pictures you may get some interest.

Yes, early 110 first reg on 7th July '83. Was originally a 3.5 V8 but had a 3.9 EFI V8 fitted @ mid '90s I think along with chassis shortened, truck cab conversion and part of the Humber Bridge added on as a roll cage. Not sure what height they originally anticpated rolling off. Intended to...

Many thanks.

I have a 1983 truck cab which needs the roof and rear window section replaced. Do all single truck cab roof and rear window sections fit my model year? Appreciate all advice!

In a Defender.

Hi all, Can anyone give me a brief insight as to which gearbox and engine combination is best? I am assuming that this will depend on whether it is for smooth distance driving or for off-roading. Is there a happy compromise? Also I have seen some owners have replaced the LR engine with an...

Hi, Is your vehicle sold? I would be interested if it is still available. Thanks.

Hi, Can you please send me the additional photos? I am new here so not sure if that is something you can do by reply or you need me to give you an email address. Many thanks.