Thank you all very much for suggestions Thanks for the link Jamiegreen i will order one i have gone to for with the rear end build now Thanks again

HI I am having trouble with the ace block,to start with I have replaced the rear ace pipes as the old ones were bad an very rusty. Now I have come to the block I have removed the old seals only to find that the ports are very corroded, putting in new seals with all the corrosion will only end in...

Ok thanks for your help I will look at welding it,if I can fine where it is leaking from,or may be the drill a hole and put a bolt in it good ideas Thanks

Hi The rear axel on my discovery 2 has a leak but not from the hub or brakes I have it off the car and have cleaned it and can see oil coming from around the weld I can not see a crack,but after a few hours a small drip of oil is there, can this be welded up has anyone done this to stop the...

Thanks will check all options from your post

Hi w My 2004 disco td5 has stared to run uneven like it is running out of fuel, when pushing down on the accelerator black smoke comes out, can anyone help ? a few years ago took out the EGA system and put in a bigger inter cooler and had it rechipped been OK up to now

Hi mjl Thanks for the info great stuff

Hi I am at the moment repairing the chassis, repairs were done in the past, but not very well someone has used alumimum plate and pop rivets:( doesn’t set well with me, so I have strip right back to mid-way point of the chassis, axel is out and now the ACE unit but need new pipes or repair, I...

Hi all can anyone help me i have taken the rear ACE pipes off as they are very corroded and need to be replaced, is it possiblel to put a better connection to the pump insted of the plastic clip that goes on there the one i have taken off just fell apart,and is corroded as well i would like to...

Hi to all I have a Land Rover discovery 4 and would like to fit a towbar and light to it does any one know if there is a kit you can buy and fit yourself I will need to tow house box and plant trailer so the standerd tow ball that comes with the car is not much use any help would be great...

Land Rover for sale

Hi Has any one fitted a kenlow heater to there discovery 2 td5. And if so how did you do it.where did you put the heater and where did you plumb it in to the systems. If there are any videos that would be good to see. Hope someone can help Cheers Martin

Hi thank you very much I think I will go with the same Cheers martin

Hi there to you all. Can anyone give me any advice. on the best type of camera to buy and install on a 2004 td5. i know there are a lot of expensive cameras out there and also a lot of cheep ones as well I have seen the one that brookwells are selling for £158.33 do you think this is the price I...

Thank you all for your input I removed the link wire and put the - side of the compresser down to earth and it now works from the horn button as normal Cheers Martin

Hi I am trying to wire air horns to my disco 2.I have read that you can wire them by using the original wiring from the horns is this the case? I have wired them using a 4pole relay from the battery. using pin 87 to the + side of the compresser and the - to ground earth. pins 86 and 30 I have...

Hi James Thanks you the reply. Not sure what you mine by putting in diff lock. As I have not done this before I think you mine put in diff lock before I take it off? not sure y I need to put it in diff lock ? as far as know it should run free with out it just in two wheel drive. Thanks for...

Hi to you all. So that I can take my time fixing the front prop shaft Is it ok to run the Land Rover with out it. It's a TD5 2003? Thanks martin Martin

Hi to you all not been on for a some time I hope all is well in these new times. I have a 2003 td5 and the front prop has gone I think it needs new spider joints but not sure does any one know if there is anyone out there that has recondition ones on the shelf ?. As don't have time to fix it as...

Ok thanks guys will look in to getting them refurbished and go from there