Did mine a few weeks back had to take floor and side rail off , pain in the ass

For aluminium door skins

Yes

Hi everyone, it’s a 300tdi 1995 90 & I need to replace the inner swivel housing gasket as it’s weeping grease, so can I get away with unbolting the swivel hub at the axle & pulling it off with the half shaft , so I can get away with having to disturb the wheel bearing & swivel housing? & if I...

Rail off now, managed to get mole grips on one & drill through nut of other one

Finally got the tank out had to take bulkhead to tub rail off well partly off , couldn’t get the two nuts off at the bulk head end ,are they supposed to be on captive nuts ? As they are just turning

Ok so I’m replacing fuel tank on a 90 300tdi on a 95 plate disconnected the fuel lines , sender wiring, unbolted rear mounting fixing & removed front tank support bracket , then slightly twisting tank anti-clockwise as removal instructions explain but struggling to get the f@#%er out any tips...

Thanks yes that’s the correct part , wasn’t quite sure as you have to buy an olive & nut separately

Replacing fuel tank on a 300tdi 90 when undoing this union pipe sheared, I think it’s on the return line which bolts to the tank anybody know a part number & a potential supplier ,so I can source a replacement part cheers in advance

Have you recently changed the alternator by any chance?

Ok so yes there’s an adjustment point under drivers seat , so it’s a lot better but still on the limit of adjustment i.e. having to use fourth click on handbrake to hold truck securely, so possibly new cable in the spring, cheers again for the replies

Oh ok didn’t realise there’s another adjustment point at the handbrake lever thanks for the replies, I’ll get back underneath tomorrow and have another go (strange that the manual which is the Land Rover manual, doesn’t mention this?)

Hi guys I’ve got a 300tdi defender 90 on a 95 plate tried to adjust handbrake as per manual ie chock wheels lift one rear wheel off the floor release handbrake tighten 17mm adjustment bolt to 25 nm then back of 1 & half turns but that was way to far I mean like just half a turn ? Does this mean...

If you have the full wading kit , what did you do with the gasket on timing belt cover leave on , take off or make a hole in it where breather is ?

Did think that the blanking screws needed a sealing washer when the kit arrived

Change from standard to a britpart performance filter ,notice a difference on the plus side seemed more responsive, does have a alisports intercooler & fuel pump tweaked to suit thou

No haven't tried it with engine running ect ,as it would engage before & engine hasn't ran so should be the same ???

Hi folks , Bought a wading kit off gwynlewis 4×4 had trouble removing old gearbox breather joint so had to disconnect the arm that engages high/low diff lock & loosen the pinch bolt that secures it to the splines (stupidly didn't mark position on splines before removing) anyways difflock...

So ive checked for continuity between the two terminals when you press the button in for washer fluid and there is , but if you probe the terminals for power there is none , so I connected power to the top terminal which just made the wiper run continuously, so took off and connected power to...

Hi I own a defender 300tdi 90 1995 plate with an original rear washer wiper switch the wipers work fine and run off the front two terminals but the rear & top terminals had no wires connected to them , my question is what are these terminals for ,I'm thinking the top terminal would connect to...