That's great thanks wammers

Right so have obviously been an idiot and overtightened the compressor nut on the single post at the front that attaches behind the drive pack and the bolt has come loose does anybody know if you can get this replaced or a way to fix it please the cab vibration is driving me mad any ideas are...

hi yeh I know but I thought I would check it still worked Nanocom is better

hi does anybody know why when I put the eas unlock on and get good idle as soon as I read faults I get faults but it loses good idle everything else is fine can get heights adjust heights everything until I try to read faults then I lose the FF in the buffer and just have numbers could it be a...

Hi I would just like to say thanks to everybody who contributed to my EAS problem and to say all is working fine now touch wood without your contributions I would have been going round in circles for ever so once again thanks

Hi Ok took compressor apart and it seems I have a thick o ring so put the old one back in now it sucks instead of blows which in any situation is OK by me thanks for the advice guys

Right thanks for help will check all tomorrow and get back

Hi all Ok I'm am officially flummoxed redid piston and seal on compressor all works great checking for air escaping from valve block outlet all good check the inlet filter bloody thing is blowing air not sucking air into the compressor what the heck have I done wrong cos I have no idea right now...

Hi yes all doors are shut it will move on the rocker but not through the nanocom

Hi Nanocom does not seem to want to change the heights when commanded to goes through the process on the screen but nothing moves any ideas anyone thanks in advance

Hi as usual loads of suggestions thanks for that and sorry for delay getting back I only did the soapy water test on the bags and block , I calibrated with eas software everything went fine then the fault appeared I will give it a go trying to clean the contacts on the sensor I have the...

Hi Sorry forgot to add it was a brand new R/F height sensor put on a week ago because of the message "R/F out of range"

Hi All I have checked the eas for leaks both valve block and compressor with the soapy water have had the new o rings installed and that is not leaking still getting Faults saying R/F sensor out of Range could this be the driver Pack and if so Is the part No ANR3900 the right part for a 1997 MY...

hi thanks for the advice oakey and I will check out the website you have given me wammers appreciated as always

yes I have nanocom so will deflate with that many thanks for you replies and help

thanks wammers I take it the bags have one way valves in them so they should stay up for me is that correct ?

Hi I thinks I need to redo the o rings in the valve block but I need the car for work I have the Schrader valves for emergency but my question is is it possible to manually inflate the bags with Schrader valves then remove the valve block to do the repair of an evening or will this cause a...

is it best to do it by jacking the car up and putting blocks in or to use the air itself because I put the high blocks in lowered the car to blocks and it kept rising back up at the back so I couldn't get a good reading on the back is that right ?

Thanks very much that makes more sense now much appreciated I will be giving it a go today and will report back how it went cheers

hi all I know that we take measurements from centre of wheel to centre lip of wheel arch and let's say it is 428mm but what does nanocom measure it in and how does that correspond with the heights of measured values any help is appreciated as I am very confused by this and need to calibrate...