Im popping out this evening with a few local lads mainly to go and scout out a few lanes that haven't been driven in a while and to see if there passable or not. meeting up at St eve around 6 ish if anyone fancies popping along. Note we are only driving one or 2 lanes and walking 2 others as...

She is getting there now MOT Saturday :) any updates on when the laning will be then guys.

I do fair bit of rust proofing and my old sprayer is knackered so made sense. I am calling them tomorrow to see if they can do a deal on a job lot of the stuff. I am looking for a tilt ramp to put up at the garage if you know of one :)

Going to check hubs etc next. i am measuring between the chassis and the wheel hub. it does have a 2 inch lift at the moment.

Never personally used it however I have just ordered this DINITROL RUSTPROOFING KIT - LARGE CAR | Rejel Store | Supplier to the Automotive Industry shall see how it goes :cool:

Thought it was worth a mention but I have always mixed wax oil with old gear oil for the inside of the chassis and used tetra under seal for the outside of the chassis. treated my old mans 96 disco years back and the boot floor and chassis is still original and 100% solid.

Fantastic :) sounds like a cracking idea shall look forward to it. :beer2:

Hi everyone newbie hear. my landy will be up and running in the next week once I get the logs in I will be off on a few free evening to a few local ish lanes around the Liskeard area. let drop me a pm if you guys are planning anything or fancy popping along.

OK so done the a frame the mounts look fine measured the cross member more accurately and it is spot on. done all the bushes and the ball joint and it has improved a little is just under 3/4 a inch out now. still noticeable though. I have been told that it may be because of the chassis been a...

Cheers for the fast replies :) the bushes are ok not the best but with a big bar they don't shift. the cross member looks to be fine so do the mounts. I have measured from the front to the rear of each a frame where the mounts are and there bang on within a mm Is not the easiest thing to...

If the unit detects a fault it wont work. normal cause is as mentioned the abs sensors normally caused by water ingress or play in a wheel bearing they are known to break down randomly though. you can either check with the correct computer or use a volt meter to check them.

Hi all I have recently got a landy 110 ex power board and have noticed the rear axle is off center by about 3/4 to a inch to the near side I have measured everything chassis wise and its all perfect nothing looks bent the a fame bushes look ok been replaced along with the rear ball joint though...

I certainly have :) once mines on the road we shall have to go for a play :). I think ive seen yours once down at Simon's @ (Lanro engineering) ?.

Yes I do ex power board one with all the add ons :) just sorting it out for the mot then I will be out playing :)

Have seen those knocking around how reliable have they been from day to day use. Have done one vnt conversion before and it ended up been a pain in the bum with the controller needing fettling about with all the time.

The L series ?

Not to far from the boarder near liskeard yourself. :dance:

Has anyone got some tips new to the td5 but not to tuning dervs have an l series running close to 195 bhp now. I have so far fitted a decat, removed the egr, fitted a new maf, sorted a boost leak and fitted a larger Inter cooler. The truck will be used as a work horse so larger turbos will be...

Hello everyone new to this forum but not to landy's. :)