I had the same issue. Ended up getting a proper puller, I put it under tension hit it a few times with a hammer and then left it over night - still under tension. In the morning, wallah job done, it had popped off.

I have standard defender doors on mine so would need a complete set of series if I choose that route. Thanks anyway

Ideal. Thanks

Oh right, i shall do. What will need to be done to make them fit? Cheers

Cheers but they're in about the same condition as the ones I've scrapped aha! Thanks anyway

Hi, I am looking for both front doors to fit my land rover. I don't have a preference to handle type although is missing its guts, I need it to have holes for push handle. I am in bridport dorset, so as as close to me as possible. I can travel a bit though. I need them to be free of rot...

Aaron, how much pipe did you find you needed? And should the male/female bits be metric or imperial and again, how many did you need? Cheers

Ideal, Thanks.

I've decided to buy a sykes pickavant flaring tool but I need to know what size dies I need for it. Does anyone know? Also, what size pipe do I need to use and could anyone suggest a good supplier. Cheers

I didn't want to burn mine, I had made the mistake of painting them and then deciding to rebush!

When you are changing bushes and don't have access to a heavy press, and have to drill the old bushes out, use a masonry drill bit rather than a metal/wood bit as it is far more effective. Jasper

cheers, that is going to be ideal for when I come to do it.

I mean buy the ready made braided one and then make up the copper bits. Yeah the ones I've looked for land rover specific are twice the price of most other ones. I knew the length may be different but I was surprised with the different. So if two different ones were the same length, it would...

I am planning to replace all the copper brake lines. I figured it is going to be cheaper to buy the pipe and bits and then flare it myself. So I was wondering whether anyone has any experience with using the flaring tools you can get off ebay for around 30 quid? Are they half decent or would...

Its 16 or 18 threads per inch (the only thread file I have is Imperial) and its about 21mm in diameter.

So I need to run a die over the thread that secures the steering drop arm onto the shaft. But I cant figure the size of the die that i'll need. Does any one know this? Nut that goes over it has the part number AEU4026 Thanks Jasper

I've just gone and bought a load. M6 25mm + 35mm I bought loads of these so I had plenty spare for future projects M8 35mm + 60mm bought about 50 of each, over kill but I got excited M10 30mm + 130mm these are more expensive so only got about 20 of each, will still have surplus thought I...

Hi, I am after a standard rear axle for my 90. I live in Bridport, Dorset so it'll have to be quite close or be sent via carrier. I'd prefer complete. Cheers Jasper Mowatt message me here.

I'll get my self one of those I reckon! Mixing up the nuts and bolts is half the fun of a rebuild right? In all honesty, I have absolutely no idea which ones go where :D.

Does anyone have a guide to the sizes and thread type of each bolt and corresponding nut for the chassis of a land rover 90? It's because I am rebuilding mine and am in need of pretty much every nut and bolt. And I'd like to buy each one from a wholesaler as it should work out cheaper. But...