I have a disco 200tdi I had the same thing when you bleed the calipers there should be three nipples on the front ones, you have to bleed the the lower pair together,then bleed the top one to to build up the pressure by only just opening it slightly,I usually do the back first its easy because...

Has anyone got a paper template for 300tdi light mounting plate, I have just found out the price of a single light box - £136 ! or a full front bulkhead with light boxes £260. I am an engineer so cutting holes is no problem, but parting with that amount of cash to hang a light on is a little...

Hi I have just bought 135 TURBO from Machine Mart, gas, its top draw once you get the settings right you can weld anything, but when you buy get a spare gas and wire, I had to make a return trip,I tested a bit too much.

I have had mine up to 95 and it was game for more on the way up to Scotland, but I bottled out because it was windy. (200 TDI`S` stick change, on bog standard running gear), and a GPS on the dash, the speedo was 4 mph out. Hope its of help.

I have 200 tdi and the same happend but when I stipped the motor out, the bearing had siezed, I got one from a local bearing supplier for £11 rebuilt it and away it went. Hope this helps as a possible solution.

Buy Disco 3 and run it on cooking oil, that will impress. And the opening line to a conversation will be, my car smells like our chppy.

HI i have just done mine, 200tdi I changed the both together as one unit it is a lot more easy, but I did mine out side my garage, you have to lift the car high enough to clear the floor pan, I used ramps and a pair of steel wheel holders (ramps without the angle) and lowered the two, on a 2 ton...

Hi I Hve Just Done Mine, The 30mm Nut Is Really Tight,the Best Way To Do It Is Put A Pair Of Big Pipe Grips On The Prop Flange, And Undo The Nut With Grips Pulling Against The The Box Section,it Leaves A Few Small Lines But No Problems,a Quick Rub With A File Leaves It Fine.reverse To Put Back.

I Have A 200 Tdi And Water Started Appearing In The Drivers Footwell, I Took Of The Side Panel Next To The Gas Pedal And A Small Hole Was Behind The Wiring Loom. Have A Look It Might Save You Alot Of Trouble. Geoffo

On a four wheel rolling set up,its the only thing I cannot check,it stops on a sixpence,even the tester said the front wheels looked up on test.

Thanks for the links I will try the pressure regulator it sounds like its the problem, I will see how much I am going to parted from,I cannot grumble it has sailed through for the last six years.

Changed the fluid last year,the system is the type that has the diagonally opposite wheels working if one fails,it does have a pressure regulator under the mastercylinder

Hi my 200 tdi has just failed the m.o.t it passed every thing except the rear brakes,they are only 47% when they should be a minimum 50%. I have put new pads on, cleaned the the callipers, no jammed pistons, in and out freely, anyone have any ideas. Possible pressure regulator according to the...

Hi I have a 200 tdi this happend to me in Ireland while touring, I got up after very heavy rain, and it would not start, the problem was the bonnet switch on the alarm system, water ran down into the switch into the connector and shorted the system, after it dried out every thing was fine. By...

I Have A 200 Tdi Manual "s" Sport Not Many Can Keep With, No Ecu To Get Wet And Very Easy To Work On, I Have Just Changed The Gearbox And Transfer Box, The Clonking Got To Be Loud And So Did The Vibration, It`s Like A New Motor,it Pulls Like A Train. Geoffo