Is it an auto box?

Hi All, I tried to change the break light bulb, as dead, the middle screw was a bit rusty, rust off on but it still damaged the Torx, can't get it out. The only tool that I found so far is that Torx so far. Any other tools that I could use to get the screw out? KR M

Ok, thanks.

Here maybe that helps:

Hello, Don't know if you have the brake light switches as well as I am having a td4 auto, but my cruise c. didn't work until I had changed the second one. Maybe yours is on the way out with first signs or a bad connection.

I know it's a 4l with which it started but found the thread interesting and it's a bit strange that a 4l is compliant while a newer 2l isn't.

No it's 2.0 TD4.

Don't understand. Have a 2002 FL1 and it shows NOx 0.59 not 0.059. Why is the older one better?

Do you have any fault codes? Could it be the lp pump? When installed a new fuel rail HP sensor it didn't start at first crank, so not sure if that might give problems as well. Might the connection be rusty or is there the overlay in?

Yes, that was my thought as well @Nodge68 @andyfreelandy but the handbook looked like it.

Resistor You mean this one or is there another one? That took 5/10 minutes just pull it out, spray and put back in. Still think it's the plug for the fan that didn't connect properly, but as I had both out can't say for sure at the moment. Any ideas on the missing fuse to see if it was really...

No none worked anymore, even speed 4 not, that's why I thought a fuse, didn't know at that time that there two one in and one out. The resistor failed back in 2019 and got a new Valeo in, so hope that's not it again. The plug seems a problem with that rubber in front.

Hello All, Yesterday the fan/heater/blower gave up completely. Fortunately it was too cold so thought to have a look for the fuses first. No. 4 if not mistaken was ok, also the right res.. Then I had a look under the bonnet for the speed 4 one which was also ok, but I got a bit confused that it...

I have unplugged the input. It drives better similar to complete unplugged I'd say, but I am not sure if it uses -40 as well as the fuel con is bad at the moment. Have started a thread on pscan.eu forum but no response on how to find the temperature yet. Might need to find a Hawkeye if not working.

Instructions now as pdf. Thank you to the donator.

Ok, thanks. That what I've done before. Thought something else.

Thanks @Nodge68 and that would mean to reset it? What would I need to do

Nice that pictures are working again.

Morning All, one of the rods was broken some weeks ago. Had it fixed for a while fell off again. Have one ordered from Amazon and one off ebay and both are longer than the original one. Can that be used or would it give any trouble to the motor? KR Matthias PS the short is the same length.