Spot on - I had considered pva, but emulsion sounds like a reasonable shout to me, as I’ve got plenty sat around!! Looking forward to getting the job done!

That’s reassuring - cheers for the info, and that job you’ve done is spot on! - great choice of material, those lights are something else! Ours won’t be as luxurious!! What did you use to seal your headliner?

Has anyone replaced the headlining material on their 110 or 90 before? I’m currently away from home and would like to order in some material ready for the job - I’ve seen a few places sell original kits at 62” width, but the wife and I would like to do our own thing, and have seen a perforated...

I had similar issues that I tracked back to the bulkhead loom, I’m not au fait with the 200tdi wiring, but can’t imagine it’s far from the 300tdi. Either way, there was sufficient contamination to cause a drop in voltage. I re-terminated mine for bath socket and pins after cleaning the...

It simply shouldn’t have been hanging out like a baboons arse. No real explanation though. Tolerances id imagine.

All sorted cheers guys. Fettled it in temporarily for the short term with a beat of heave ho and the hammer. Bearmach got back in touch to confirm it wasn’t right too. Arse end bushes all squared away for the west coast!

Wallpaper scrapers at the ready - I’ve also nipped it tight in a vice overnight see if it settles down a little! Tempted to go and fit the led lights to the dash in the meantime!

Cheers guys, I’ll aim for the smash approach to get us back on the roads for the time being, and go for a refresh at a later date when I’ve got less of a tight schedule! Turboman - I’ve just gone for standards at the struts for the time being, with a view to upgrading to poly at the same time...

Yes life once again with the green oval!! :) already snapped the rear strut mount stud :) That being said the retard who installed the struts didn’t bother with the inner washers!!!

They were in sealed Bearmach bags directly from them so hope they aren’t cheap knock offs haha, I’ve had a pop with the vice but it doesn’t help, loving the idea of jacking em up with sliders though!

so thinking I was doing the right thing by going polybush (Bearmach kit) due to simplicity in fitting - every time I fit the sleeve to the trailing arm lower bush it pushes the dam thing out each side by apx 3mm - never gonna fit that in!! Has anyone else encountered this? At a loss atm, have...

Do you mean this switch (attached).

I should have added about the switch, is it the 3 way one you’re referring to? I’d pull the switch and see what colours are there and go from there with the help of a wiring diagram.

Well you’ve confused an aircraft electrician! So going back to basics here and ignoring the courtesy light & new pod - do your Speedo backlights etc come on with your lights?

So the wife isn’t getting along with the Dormobile dormatic seats we have in our 110 - probably just a tad too high for her little legs, and she’s also wanting an extra seat in the 2nd row. After we’ve found something reasonable to put in their place, ie totally standard seating front & 2nd row...