Just a thought I read up on this before and one of the things I picked up on was keeping your pump submerged in fuel all the time IE keep your tank above 1/4 tank. This is what I have told the wife to fill up when its the quarter to prevent the pumps drying out !

Shocking video of Range Rover crashing through bikers after they surround the vehicle during annual street ride | Mail Online Sorry I took it off as it was already posted elsewhere

If you have a hungry pack of bikers in the hunt for you would you not panic !

delete

Have you got the right cap there are 2 types of one for diesel and one for petrol!!

Another good right up Saint hope all is well

Good luck Saint fingers crossed this end, I feel for you it be nice just to enjoy the car rather than worrying about bits and bobs

Our L322 on tow with a twin axle caravan 17.8 to the gallon on petrol Normal running around never below 15 to the gallon On a run on the motorway 24 not loaded up ! This was recently !

Here it is fullfatrr.com - View topic - Air Compressor Strip down

Take it off and give it a bit of a strip down and clean. Normally its either the solenoid faling on it not closing so springs might have gone weak. The main spring either has snapped via corrosion. I did a how to on it Ill see if I can get the link

Saint worth a check as these were knackerrrrrd when i got mine. it puts the EML on an dont go away!

Dez The motor on these is just a pleasure to drive all the time be it gentle cruising or putting your foot down. I must admit it is very smooth on gear changes and juts follows through with the power. Mine has done 70k now on 04 plate. I change the oil every 5k since I had it at 58k. I keep...

I was in the same boat as you a couple of years ago. I found that the diesel L322 was a lot quicker and quiter than the td5 ! But after a deal gone wrong with a guy that backed out I ended up test driving a 4.4 v8 petrol. After a five minute drive I decided then that petrol was the way...

Just by interest what make bearings were you using??? Was it ****part or Timken ? I have used both and never again will I use ****part for bearings they are utter shiiite !

Just a guideline it was 200 + vat at my land rover stealers and same from the indy! Make sure you put the one with the metal wheel fan instead of the plastic as Saint will point out too. Also you can do it in a day and you don't need special tools to do it !