i will, yes engine turns by hand. Has a heck of a compression though. But nothing weird i presume. Has ran shortly with a fully charged battery and when it just "caught", if you get what i mean. Still turned slow, just happened to fire up. Makes me think there is nothing wrong with the engine per se

The engine is in a test rig. Its not connected to anything else; Ergo, its outside any wiring harness. Im just running starter cables from an external battery to the starter motor.

I could do that yes, what would/should it tell me?

Battery good, voltage no clue. It drains the battery rather quickly though. Maybe a short?

This is the battery i use in my driving landrover. It throws that around fine. I dont think the battery is bad. Earth and positive are just jump leads i connect with the terminal and ground. I wouldnt think that is neccesairily bad?

Rebuild a petrol engine, the starter doesnt like to throw it around. Happens on a charged battery. Took out the ignition so doesnt spark/wrong timing. Bought the starter used, but rebuilt and refreshed. Anyone has any clues? Please see attatched video.

Havent been able to verify the fitted gearbox. Numbers in known locations are missing...

I did some digging, and found out that the suffix C box began in 63'. Also, my bearings are still of the metal kind (on craddock the metal ones go up untill 64') While the plastic kind of bearings came out of my fitted box. So, am I correct in assuming it wont fit then?

Gears come from a 2a gearbox suffix C. So, might be different?

Hi all, I recently broke a tooth off of my intermediate gear in my gearbox. Luckily I had a spare gearbox lying around so i took the gear from that one. Though; they are slightly different. Anyone know if its ok to interchange these two? It doesnt seem like it wont fit. But rather im more...

Some bearing pics. thanks for the input! alr id need to check that for sure, thanks. As for the rings, i have some A and B pistons in the engine. Am i correct in assuming that if i want a new fresh set of rings, i should buy 4 sets of standard sized rings? I found this piece of info online...

i have the tail, just missing the top. I feel like this is where its all going eventually. Just getting new rings and shoving it in. Taking for granted it might run a bit mucky.

I havent reassembled it yet, its all loose parts as of now; so i didnt waste the parts atleast! Yup, seems about 10 thousands indeed. Some new info: For starters; i measured wrongly. The gap isnt 1.8mm; its around 1.15. The remarkable thing is that for the entire bore. its 1.15. Give or take...

Ah dangit, i really hoped i could avoid bringing it to a shop. Takes a nice cheap engine to a more expensive thing. ill use the trick of putting the rings at the bottom where there is no wear. Nice once. There is a small ridge at the top, yes. Any opinions on just rolling with it as it is...

@kermit_rr i will check, it is likely that its pretty round. Since i put it in already at 90 degrees, and i know that it moves similarly when in correct orientation. This would mean the cilinder is at fault? what are the remedies to this? I took the engine apart as a revision, i got it for a...