No need to replace the steering lock, simply buy an emulator "£25-30 on ebay, unplug the steering lock plug the lead into the emulator and bingo, problem solved..
Unhook the negative terminal with the ignition lights on, this should reset the ecu and then enable you to start the engine, next, turn it off and on again andlisten for the buzz from the steering lock ... chances are that you won't hear it, so...
2009.Discovery 3 aux heater problem, it smoked one time when I first prompted it, but did not continue to full burn, I can test the function.with my computer, it says the module and heater are fine, but the pump test comes up as fail/re-try, I...
Cured it, air temp was loose connection to the sensor tucked up behind the throttle intake, the oil does indeed have an oil temp sensor price @ £175+ it is located at the front just below the starter motor, luckily again, a loose connection, but...
I did, I pulled out, cleaned and replaced them all in all 3 boxes, only visual checks on the relays..for what that's worth, but cleaned the contacts, the noise in the footwell sounds like a low buzz, lasts just for a second or two, when under the...
Hi, it's a freelander2 07. 2.2td. I've checked removed every fuse on it, there are 2 codes permanent oil temp, air intake temp, new sensors are on order, when I reconnect the battery other codes come up 1 relates to the BCM
If I disconnect a battery terminal it starts and runs really well and I can stop it and restart it all day provided I leave the key in it's slot, if I remove the key, and then re insert it, the dash lights up, but they go out again and there is a...
Hi everyone, first time on this forum, so here goes : insert fob, press start button, depress clutch, press start button and nothing ! except for a noise down in the passenger footwell, pop the bonnet, disconnect and re connect the battery earth...