I did mean anti clockwise - I'm going to try a bit of heat!

Ha ha No. Just updated another thread with a resolution and noticed I hadn't updated this thread!

The solution to this was crap wheel balancing by Kwik Fit! I took it to another place and after spending about an hour on it and it is now fine. I initially ruled out wheel balancing as it had already been done!

I found the resolution to this. Behind the centre console sits the heater matrix. It is sealed by a foam gasket. The gasket had failed and lettinghot air blow out continuously into the footwell. I sealed this with some sealant and all is now fine!

Hi all i'm having a bloody nightmare removing the fan on my 4.0 V8. I've done it before with the tool and with a sharp blow with a chisel. I know its a right hand thread and need to turn it clockwise as you face the engine. I've even made a bracket that prevents the water pump pully...

I asked a question for pointers of where to look. That is why I described the symptoms. If someone more learned than me could, for example, suggest that something might NOT be the cause as it would vibrate continously not at certain points then that would help in the process of elimination. Yes...

So I've had all the wheels balanced and apparently one of the wheels had 7! 35g weights on the inside and it only needed one. An experienced guy ay It's spent good hour and half on the wheels so I hope this is the issue I had already us them done at kwik fit but they spent about 15minutes on...

Thanks for the reply. Oil I changed was very clean and smelt fine - I don't think it had ever overheated - symptons seem to point to switch. Any idea where I can but one - I can't seem to find anywhere that sells them?

Just found some previous posts on this subject (why I didn't find them before I posted I don't know) and looks like the front temperature sensor is likely to up the spout. Anyone know where the cheapest place for a replacement might be - I can't seem to find any listed. Thanks Paul

Hi All Yet another issue with my new Disco 2! The auto transmission temperature warning light is pretty much always illuminated once warmed up. It goes off I'm driving at a steady speed - say 70mph on the motorway but if I drive slowly around town or any faster then it comes on. The car is not...

Thanks Graham, I'll check it today. I was going to change the gearboix oil and filter so I'll be filthy anyway!

Thanks for the reply. I thought this but would it not vibrate at all speeds? I'll check them out anyway!

Hi All I have a query on the operation of the heater matrix in my Disco 2 4.0 with aircon. I recently noticed that the heater matrix always have hot coolant pumped through it and therefore it is always boiling hot. According to the workshop manual this is normal and there is no valve in the...

Hi All My recently acquired 4.0 Discovery has a vibration that is particularly noticable at 48mph and 80 mph+. I know there are a multitude of causes for vibrations and I have read several posts but cannot really pin down the source - it all seems to be a bit of trial and error. I hope that...

Solved! Replaced the fusebox and all is well so confirmed it was the IDM. Thanks for the pointer to the IDM Sierrafery -I owe you a beer! Thanks all.