Yes go from the seat box center plate. Clean and a tad of lube may do it. Could be ratchet itself worn or the pawl that catches in it has gone/worn. When learning to drive a long time ago I was taught to pull brake up with thumb on button and...

Removing the gear lever is a case of just pulling it up and off ! But, if it was only that easy. The gator should pull down away from the knob. Then the lower part of the gear knob has two plastic prongs which grip a recess on the stick. It does...

The key has a chip in the black plastic part of the key. It is this chip that 'talks' to the coil and sends correct signal to the immobiliser module and then to the engine ecu. Without the chip the car will not crank over. Ignition will work OK...

Sorted it with a thingy, tie wrap and some insulation tape. 🤣🤣🤣🤣🤣 Having a beer tonight.

Cheers Buddy 👍

They are self-under sealing… clever motors

OK, I found the following installation reference document HERE. Very disappointed by the supplier that they do not have an English equivalent guide (only available in German 🤬). Just in case someone else needs the document in the future, I have...

Hi MCBRL search the internet for the following document d2_electricalcircuitdiagrams_2000.pdf and also discovery-ii-electrical-library.pdf

Looked at it sitting in the corner of my garden sulking because Im not paying it attention...... So Im leaving it for another 6 months.

I got carried away leak tracing and sealing with Captain Tolley and Tiger Seal, decided to rip out the upper windscreen over seal. This might not have been too bad, but then I had a bonkage mishap when fitting the new one. The good news is...

Yes schrader valve for aircon refill/ servicing etc , should be a second one somewhere

As per your other post it's the filler for the air con gas.

I assume the tailgate was functioning 100% before. So whoever did the work in replacing the tailgate would have left some pencil marks to aid realignment when fitting the replacement, something similar to bonnet and side doors removal and...

Start as above, check boot trim all around for security and nothing is obstructing the tailgate. If any parts have been changed, start there. One point I came across recently was that the green connector had been connected the wrong way around !

If you really want to advance the miles, practice on the old one. You may end up with digits misaligned, then all who look will think you have tried to turn it back ? Could be you have dry joint or two in the solder, it may well be an easy fix...

Replacement cluster is all good. It's in decent condition too, bit upset it's only got 153k miles on it. Mines up to 225k (and the rest of the vehicle definitely reflects that) so I was looking forward to making 250k one day 😅 might see how easy...

Just a quick follow up to close out this Thread. I too bought and fitted this. After 4 NoS and a new brit part stabiliser, it now all works. The earth on this modern equivalent appears to bind in tighter to its correct position on the rear of the...

And the winner is Found the bugger too. No speed camera today.

That's something I was wondering. I've used a test and polarity probe and it appears the signals and voltage are reaching the cluster so I have to assume it's the cluster that's gone awry. Ordered a used one so I'm hoping for a plug and play...

I'm not sure you can put 12v through the Disco' circuit board without possible damage ? The later models are set up for 5Volts I believe. Check earths and connections for security and damage.

Mot fast approaching so booked in for Friday, so I replaced a damages front door, (Banged up) the welded up the rust on my front windscreen (Bad Winter), only to get the 3 amigos for the first time, which the lead me to get a used Nanocom, from a...

Plus 1 as funny enough also taught the apprentice’s at work a simple appreciation along with most of all good manners as a simple plse and thk u goes along way these days When I was an apprentice my senior fitter was an ex para , I was...

Indeed it’s really made my day , so nice being able to share what I learnt from when I stripped all my air suspension down So nice when members come back to say a simple thank u which goes along way, not forgetting it’s always a team effort...

Many thanks to @gstuart whose post [https://www.landyzone.co.uk/land-rover/air-suspension-red-light-solved.384856/post-5500726] solved my nagging suspension problem. For those that don't like a long read, the problem was a loose pin in the...

I tried that with mine, even the special socket wouldn't do it.:(:(:(

I think applying something regularly is the key to the preserving underneath.

I didn't know it when I bought them but all 3 companies are British.

Oil and diesel mix twice a year scooshed on wi the garden sprayer. Nae rust here.👍

Most tyre fitters or garages can remove lockers in a few seconds. Simply buy 5 replacement standard nuts. You can't replace studs with European style bolts, as there's no threads in the hub flange to screw bolts into.

I've just found out it's for the air conditioning, but I don't have it anymore so it's redundant!