Any recommendations for where to get replacement breather hoses e.g. the one here for the crankcase breather hose? Having a quick search around, some seem very expensive (could be they’re just out of stock and don’t want anyone buying them).

Have you drilled a big hole for the RR umbrella to go in? @Anaconda

I've had a few things that rattle over the years, including: 1 The alloy heatshield that goes on the gearbox mount on the exhaust pipe side. I assume it's to stop the rubber mounting block getting hot. Mine had a crack in it and rattled. I...

Yes

Seems too regular a sound to be a clamp and they don’t seem loose

Educated guess is the propshafts so I’ve ordered both front and rear and will hopefully have a clear afternoon this week to replace them. Buying new wasn’t a huge amount more than having them rebuilt, and much quicker too.

Dropping this in somewhere tomorrow for them to take a look. Realised my trolley jack won’t work on the raised Defender. Another tool to add to the Spring shopping list.

Yes. Doesn’t make as much of a noise when I’ve got my foot down on the accelerator, but shows up when I’m at lower revs or ease off. Does not make the noise on idle. It does sound rotational and fairly “regular”

You ask the sensible questions. We just look at pictures.

Abrasive is abrasive I guess 😀

Don't normally believe most of the hacks you see on the net but saw similar on a well known site so gave it a go before buying new lamps. Wipac crystals. Bit of tooth paste on the wifes washing up sponge and a minute or two of roundy roundy...

That is a VERY good question @marjon . It has only gone into the engine oil (at the recommended dilution). The plot thickens. 😂

Another short clip here with the same rattle.

Grabbed a bottle of UV leak detection fluid from a mate, having cleaned up the underside with some degreaser. Under UV torch in the dark, this seems to be the offending area (at least the immediate one I can see). Will take more of a look in...

Thanks folks, appreciate the welcome, meet the Wolf, picture attached :)

It’s dark so I can’t take a good look, but thought someone may be able to play “name that tune rattle. It feels like it’s coming from the rear but this may be the sound travelling through something else. Happens when I’m off the throttle mostly...

If the top down to the head gasket is free of oil leaks, timing case is free of oil leaks then it's only really oil filter housing, engine cooler pipes, lift pump and vacuum pump to look at. Stick the breather pipe onto the inner wheel arch out...

Great advice thanks

it should mist into the air filter for burning back through the engine. Now if you have loads in the bottle after a few days that’s where your problem is. The pipe should mist/breath from sump to crankcase so should not dump loads of oil...

And what will it tell me Phill? No oil, some oil, lots of oil?

It all tasted like oil 😉

Meaning leave a bottle on it with some tape / ties? I’ve cleaned the top of the engine 3/4 weeks ago and it hasn’t gotten any dirtier. I’ll give the underside a spray with some cleaner and give it a jet wash at the local garage. 👌🏻

Will check 🫡

Had a roll around on my back to see where most of the oil was coming from on the driveway. Seems to be coming from most areas. Anywhere you’d be starting first or just usual defender life?

Checked all fluids, looking good New battery - now have full beam working again Replaced a bunch of rivnuts that the previous owner had installed poorly Rewired in a very simple Bluetooth amp to a couple of 10 inch speakers in the front to...

Thanks Phill!

Nothing missing… Search wading plugs

Nothing missing from them, or have I lost something along the way? 😂

I’m still learning about the Defender 90 as I go. Was hoping someone could help me understand what the two “holes” are on the photos attached. These are captured from a video I took underneath when I was looking for something else. Appreciate...