+1^^^^ The pipes run along the top of the chassis left side, very close to the exhaust..
Remove the inlet filter from the compressor to prove it's sucking by applying you finger to the inlet.
All of mine do. Hence accidental drain battery one time when I forgot to unplug front and rear cameras, and left her sitting for 2 or 3 weeks. π€¦ββοΈ
Once youβve come round a bit, realise the opportunity this presents and weigh up your options from here in ; Itl soon lift your spirits :vb-angel1:
Rest up Itl be fine.
I had an accident today with my p38, drove into someone else's back at around 30mph.
Front crossmember bent as he had a towbar
Is this the end of my range rover?
Front crossmember is part of the chassis and not bolt on so..
If you have to make a lot of stop start manΕuvres the suspension will adjust depending on what is needed for the car to decide it's height status. I'm not 100% certain but when the car reaches a certain lower speed like at the lights it will...
If you go fast enough on your local drive and the suspension is not locked, then there will be height changes related to speed. I keep both mine locked at motorway height.
Only works until the big parcels reveal small items! I did tell her that I can use the parts I don't need when I'm finally done. Which actually is the plan, so if someone needs a RRC steering column, let me know!
Get a jumper pack and connect it to the live on the starter motor and an earth. π
That'll restore power to the vehicle while you unlock and start it up.
I know when they regen buses it is usually done it's static. The amount of smoke it can produce gets the public worried, especially in a crowded bus station. I speak from experience.
Apparently, almost all the stuff I ordered beforw and during our summer vacation, ehich is ending tomorrow unfortunately, has been delivered. My catsitting dad was so kind to also take delivery for that. He just told me that it looks like...
After spending some time thinking about designing a tool to hold the fan to undo it in the end i went and got a piece of steel13mm x 3mm x260mm long and it did the job one hit and the fan was off now all i got to do is wait for new pulley or...