1. roger01

    P38 2.5 low on power, can't reach max rpm

    Hi, I am following the thread as I am having a similar problem, with a 2.5 dsl, out of interest, which Kingbolen Ediag do you use the Elite or the yearly subscription one
  2. roger01

    2000 RPM max

    Thanks for the input guys, no sign of external intervention, had all the pipework apart so no probs there, the diesel is no more than 6 months old as I replaced the in tank pump September last year, I have just purchased a Nanocom on fleebay, I am away from the 21st till the end of the month so...
  3. roger01

    2000 RPM max

    Hi all. to continue, the MAP gives out 1.8v at tick over this rises to 2,19 - 2.2v at 2000 RPM, tried a new sensor (Lucas) no difference, put in a couple of pressure test tapping points, the Turbo kicks out around 0.2 PSI at tick over this rises to 3.6 to 4 PSI at 2000 rpm, the reading is the...
  4. roger01

    2000 RPM max

    Hi Guys, thanks for the replies, sorry for the delay been out of town a couple of days, tried with the MAF unplugged and no change, the pipework to the MAP was replaced maybe 6/7 years ago at the same time I did the leak off pipes and all looks ok, is there anyone in the Wombwell - Barnsley...
  5. roger01

    2000 RPM max

    Hi I've had a 2001 2.5 HDSE auto for many years, been laid up maybe 4 years or so (leaky airsprings and fuel pump playing up) although not on the road always fired up and shunted up and down the drive every few months. Finally got around to replacing the air springs, OH the brakes, new pump in...
  6. roger01

    P38 Flat Battery Lockout

    Thanks for the input guys, yes I checked the loom from door out station to the plug behind the front door post in the drivers foot well and then on from the corresponding socket to the BECM using a 10w bulb as a series load and everything was fine, did all this when I suspected broken wire or...
  7. roger01

    P38 Flat Battery Lockout

    Hi back again, as mentioned earlier operating the unlock switch and the indicators flashed, operate the lock switch and nothing, swapped the wires over on the door switches, and as expected the actions are reversed operate the unlock nothing operate the lock switch (which is now connected to the...
  8. roger01

    P38 Flat Battery Lockout

    Yes know what you mean about the sync, mines a 2001 (been together for 10+ years or so) and what I found in the past that after battery replacement (key or car) you place the key in the ignition and it flashes twice, don't press any buttons take it out and put the second key in and that flashes...
  9. roger01

    P38 Flat Battery Lockout

    Know what your your saying and yes that may be the end solution but unsolved problems really stick up my nose there's only 4 control lines and 2 power lines from the Bcm to the out station ( + 2 from the window control/monitor which I assume govern current sensing for full open/close and anti...
  10. roger01

    P38 Flat Battery Lockout

    Hi, the door switches are tested and all fine, I have have even swapped the green/red (lock) and the blue red (unlock) wires over then instead of the indicators flashing when I unlock and nothing on lock it's as expected the other way round, when I lock the indicators flash and nothing when I...
  11. roger01

    P38 Flat Battery Lockout

    P38 2.5 DHSE Auto Hi everybody it’s happened again, after the last flat battery fiasco and subsequent can’t sync the fobs because the alarm is still active when battery is re-charged I hooked up 60 watts of solar panels to stop it happening again, the P38 is a gracious old lady that now only...
  12. roger01

    P38 key code lock out

    Hi all, ya'll ready for the weird twist to the saga, so messaged LR direct for the EKA after the local main dealer came up empty, got an automated response stating 4/5 working days for an actual reply, checked the door switches ready for the impending code arrival, both duff, no probs connected...
  13. roger01

    P38 key code lock out

    Been to Guy Salmon at Sheffield today to get the EKA, they pulled up all the details for the car but the EKA code had been blanked out, they looked up one they had searched and obtained last week and that was now blanked out, they believe that Land Rover have now stopped dealers from obtaining...
  14. roger01

    P38 key code lock out

    The locking has been fine all the time I have had the car, from both fobs or both front door sill switches, never actually used the key to unlock the car so don't know weather it ever locked/unlocked via the key in the first place
  15. roger01

    P38 key code lock out

    It's a 2001 2.5 Diesel, when I bought it some 7/8 years ago I was told it was the HSE with all the bit's and bobs (Harman Kardon etc), Tried the reconnecting the battery with the key is pos 2 a couple of times but no joy, if I manage to get the EKA from the dealers i will have to take the door...