Mike will post an ad in the for sale section like everyone else

Mine too is doing the same so any info from other users would be great

hi mate its a petrol 4.0. where on the engine is this sensor and wiring?

HI mate thats great news cheers. what part do i need to go hunting for on ebay etc? Door actuator?

After attemoting to lock my p38 all locks went down except the drivers door? When sitting in the car and i push the drivers lock down and up all seem to work. Just when i use the key fob it dosnt. It works when i use the key in the lock fine. Where should i look? what parts do i need to buy...

After having my head gasket changed on my p38 the temp guage does not seem to go back to the correct operating temp. It just sits in the blue. The little red light to the right of the guage does not come on saying temp failure so i stuck. Any ideas where to look???

i have no idea to be honest i read that someone had slight water ingress in theirs which was causing an electrical fault similar to mine and he went to the BECM cleaned up the points??? and all was fine.

Is alt esay to get to? The battery connections seem fine at the mo. I bought a new fuse box thinking that maybe the garage poured water into the fuse box and knackered it by mistake? Maybe its more simple than that then?

i take it i need to tighten a cable on the alt then?

How do i access the BECM exactly to check the points etc? As im having an electrical problem.

where do i check these wires from mate? do i take the dash out etc?

Hi there, how do i get to the BECM as im have simliar problems.

Hi tim seal My rangie had an issue where i had the heater o rings changed and when it came backa new defect came up being whilst driving along all the dash lights will come on and guages drop to zero. this been happening fro a week now with means to investigate but no time. Now it has started...

cant argue with what equates to 36mpg for a v8 on lpg though. Plus diesel is literally through the roof. some places here in cornwall its £1.09!!!

hi thanks for you responce, will i be able to carry out the work myself if its a case of taking the dash apart i can do this im sure. I bought a new fuse box thinking that they may have poured water in there when doing the head gasket. Or will this be a case of needing a new instrument panel...