OBD plug (Data Link Connector )

this is photo of resistor on my dlc

if the sensor not set right would that infact cause it to cut out stall whilst driving

what is rave

does any one have a picture of the flywheel on a p38 .25.dt so i can see what the crank pick looks like

any advise on how to set this there only about inch of adjustment

was in main shaft broke in two oh dear

its a new crank sensor also infact second one first one broke as i put it in to far now i noticed slide adjustment on these do they need to be set or is it just case off putting them in

when my engine was cutting out code was 142 and 144 with snap on tool engine begin control i replace injector with wire made no differance to it cutting out

new engine out of bmw 525 will this do

i had same problem i put new fuel pump and injection pump on still dont it then dropped a vaule in number three cylinder but dont think that was the problem going to put other engine in on monday does injector pump need to be coded etc or is it just straight in

i was going down motor way about 60 ish when suddenly the was no drive aa told me my cluth wach was gone. i know it not the role pins in clutch fork as ive done them before so took box out yesterday and clutch looks fine i selected gear in box when out and the shaft not turnin (oh its 5...

hi yeah coil spring and took me about six hours the taking out the bags and putting spring was easy the hard bit i found was putting the retianing clips in but i got big hand think that was the real problem lol cost me 480 off ebay and i dont regret it one bit the cheapest price i seen...

am not sure but i can hear the motors turning tryin to fix clutch first

does any one know if you can buy a replacement part with out the cat that way for an mot we would just have to swap them over i would do it once a year if that was the case chris mercman15