Or the feed to the cigar lighter....but as mentioned above, take a (Fused) feed from the battery to a suitable relay, & switch the relay from the "ignition-fed" source.

Well, just ordered a set of callipers/disks etc for the front, when I get round to fitting those (just so I know everything is shiney & new ;)), I will do a complete fluid change.

Well.....I kinda thought this...but surely, if I loosened off the bleed-nipple to release any pressure, the calliper would/should retract enough allow the hub to spin?

OK..Long story, but I'll try to keep it short..Im now stuck for Ideas 1) Horrid screech from RNS wheel, which is also too hot to touch....Quick investigaition shows a sticky caliper. Disassemble..grease/copperslip appropriate bit & Re-assemble. 2) Rear wheel still over heats...Splash the...

Subsequently found at Crays Hill, having been used as a Ram-raid vehicle. Apparently: "they" got disturbed & fled the scene...by the time the police had got there, the roof & rear doors had been nicked. :mad:

ratchet-strap a storage-box in?. If you still have the "dickie-seats" in place you should be able to use the seat-belt straps as suitable anchor-points? Sent from my GT-I9300 using Forum Fiend v1.0.1.

:( dont say that! ... mines been fixed for about a year now...I *DO* hope it lasts a LOT longer! ! Sent from my GT-I9300 using Forum Fiend v1.0.1.

Near the Back?....LHS (When looking from the top: Bonnet up?).....IF this is the case, there's a high chance its the Fuel Pressure Regulator. Cheap repair kits available....but its a bit of a nightmare getting to it... EDIT I used this guide when I did mine: http://www.discovery2.co.uk/Fpr.html

1-1.1 bar....I think

No Pics of the (Free) Sat-Nag software that shows By-ways/lanes ?? ;)

How about a Poachers-trap type thing (Blank shot-gun shell, with a spring-loaded firing pin type cage araound it) in the cab?.....connected to the clutch pedal?. Would make a hell of a bang in the cab.... Just dont forget you fitted it! EDIT I see this approach has been covered earlier in...

The bay of e?.. search 18w led worklamp

I wave at all Disco's, Defenders/Series...& even Freelanders (Having had a couple of them myself)... But there is a problem....I often get to drive different vehicles from work....& when I forget I'm not in one of my Disco's, I *DO* get odd looks from other Landy-drivers!.

Or indeed, a dieing starter motor would make the engine crank slowly, even with good batteries. I recently put a new starter-motor on & it now cranks faster than it ever has before, and starts REAL quick.

Havnt you got work to do?? ;)