1. M

    P38 small puddle of fuel in injector well

    Thanks just bought the gates fuel hose and bunch of clip ties Thanks Tony
  2. M

    P38 small puddle of fuel in injector well

    Thanks again for the help !!! Much appreciated nice tip about the cable tie Thanks Tony šŸ‘
  3. M

    P38 small puddle of fuel in injector well

    Thank you so much I will get a socket for the tool box No bloody good hose šŸ‘ Strangely when the car is cold the NBG leak off hose is hard to pull off but after driving when engine is hot I’ve discovered it just slips off Looks like it’s leaking from the NBG leak off hose Thanks for...
  4. M

    P38 small puddle of fuel in injector well

    Thank you very much for the help What does NGB pipe mean ? New washer was used I will try and tighten the fuel injector tomorrow This is new to me so I guess I loosen the loose union with fuel pipe and move to one side and just use a box spanner over the fuel injector and give it a turn...
  5. M

    P38 small puddle of fuel in injector well

    Hello I own a 2.5 p38 diesel range rover I had a problem with fuel puddling in the well of fuel injector no1 closet to bumper My local mechanic changed the leak off hoses and changed the injector It is a lot better but there is still a small amount of fuel bubbling in the well I took...
  6. M

    Sunroof won’t close

    Just mistakenly pressed the wrong switch I don’t normally use the sunroof All fixed thanks for the help the switch contacts were tarnished but because I manually closed the sunroof I needed to turn the screwdriver back a quarter turn as per manual ( thanks Flossie ) It reality I turned the...
  7. M

    Sunroof won’t close

    Thank you very much
  8. M

    Sunroof won’t close

    Hello , life was great this morning until I mistakenly opened the sunroof instead of the drivers window. And it did decide to rain just at that moment The sunroof has stuck open and will not close using the switch ,I can hear the motor work on opening but not closing So I have managed to...
  9. M

    35 max speed message

    Thank you again !!!
  10. M

    Air suspension problems

    Oh just thought I would show you guys why the small 40 amp fuse kept popping after my tragic attempt to repair the compressor, I didn’t pull the cable back tight before inserting the rubber grommet Might help someone not to make the same mistake
  11. M

    35 max speed message

    Hello again So after getting the car off the bump stops I have the 35 max message Can this be cleared with the free rsw software Thanks
  12. M

    Air suspension problems

    I see ,so in an emergency you could just remove the four pipes from the valve block and then connect the schrader valves, pump up the four air bags and go . That might be the way to go Thanks again !!
  13. M

    Air suspension problems

    Well that didn’t turn out too good 😊 After fitting the new thermal switch and having a nightmare of getting the brushes to stay in ,I must of shorted it somehow ,because when i refitted the compressor. The small 40amp fuse in the engine bay kept blowing ,which prevented the car from starting...
  14. M

    Air suspension problems

    Thanks again to you guys for taking the time to explain how the system works and what to check for I’m very grateful So I decided to get another compressor and guess what it’s now working So thanks for the help !!!!!
  15. M

    Air suspension problems

    I can’t thank you guys enough for the continued support .Im starting to think this might be beyond me to fix . I have clear all fault codes today I did have slow 35 max speed and please see pic but now they are clear . I did the turn of software restart engine no luck I grounded the orange cable...