• Mark Piercy
    Mark Piercy reacted to DanClarke's post in the thread P38 dse engine disabled with Like Like.
    Ahhhhh.... there is a page visible in Nanocom "Security" pages that tells you whether your BeCM is LOCKED or UNLOCKED. By all means go look at it but whatever you do, do NOT try to change that setting. If it says your BeCM is "Locked" then you...
    Tuesday at 17:30
  • Mark Piercy
    Mark Piercy reacted to RangeRoller dt's post in the thread P38 dse engine disabled with Like Like.
    Moot apparently. If you can’t listen to advice it’s impossible to help you. We are all repeating ourselves. Plenty of advice in the searchbar or JLR maindealer. Good luck.
    Tuesday at 17:30
  • Mark Piercy
    Mark Piercy reacted to pwood999's post in the thread P38A EAS question with Like Like.
    Generally a diaphragm failure causes problems with the system not filling the tank. My guess is it's probably ok. Also if the NRV cones have any wear, find the best one and use that for NRV-1. The other two only impact operation if the...
    Tuesday at 10:51
  • Mark Piercy
    Mark Piercy reacted to Datatek's post in the thread P38 dse engine disabled with Like Like.
    Take the seat out, take the lid off the BECM and check for condensation. With the seat out, you can check all connectors. There is no indication from what you say that the BECM is locked out but of course I could be wrong. You need to look...
    Tuesday at 10:50
  • Mark Piercy
    Mark Piercy reacted to RangeRoller dt's post in the thread P38 dse engine disabled with Haha Haha.
    Not to nanocom Willy nilly Everything from post #2 onwards 😂 Avoiding the issue is not the same as resolving it. It’s your call.
    Tuesday at 04:28
  • Mark Piercy
    Mark Piercy replied to the thread P38 dse engine disabled.
    I'd get the key/s sorted first before writing the becm off. You need a functioning key either way and then go from there👍
    Monday at 22:03
  • Mark Piercy
    Mark Piercy reacted to backinblack's post in the thread What did you do with your Range Rover today with Haha Haha.
    Make it think you need to take it off.
    Monday at 19:46
  • Mark Piercy
    Mark Piercy reacted to Datatek's post in the thread P38A EAS question with Like Like.
    You also need to check that the cone shaped nose on the NRV's are smooth with no indented ridge.
    Monday at 19:45
  • Mark Piercy
    Mark Piercy reacted to MrGorsky's post in the thread P38A EAS question with Sad Sad.
    I'll have to buy some more O rings then! Bubbles at the dryer were only seen when the compressor was running. Once it went off there were none. Even with it running they were very small bubbles, small enough to make a foam around the top...
    Monday at 19:10
  • Mark Piercy
    Mark Piercy reacted to pwood999's post in the thread P38A EAS question with Like Like.
    Tank leak will usually be NRV-1. With the system off, air leaking through NRV-1 will pass through the dryer, and lift the diaphragm, hence inflating the balloon (path of least resistance). Some of this air can also escape via the dryer seals &...
    Monday at 18:19
  • Mark Piercy
    Mark Piercy replied to the thread Ron Box Purchase.
    It'll depend on how well it's tuned👍
    Monday at 17:59
  • Mark Piercy
    Mark Piercy reacted to Datatek's post in the thread Ron Box Purchase with Like Like.
    If the car is an auto, it will in due course knacker the gearbox as effectively nullifies the torque reduction required on gear shifts to protect the clutches. Plenty of ooomph in the M51 if it's running well IMO.
    Monday at 17:59
  • Mark Piercy
    Mark Piercy reacted to Dippypud's post in the thread Ron Box Purchase with Like Like.
    Get it running as best as it can, before even thinking about wasting that sort of money ...
    Monday at 17:59
  • Mark Piercy
    Mark Piercy reacted to RangeRoller dt's post in the thread Ron Box Purchase with Like Like.
    A great man once said “fitting a tuning box to an already unhealthy engine is as useful as tits on a mars bar”. He said that to me. And he was right. As usual If you wanna go down that route look up p38 PSI or Synergy box but unless your...
    Monday at 17:58
  • Mark Piercy
    Mark Piercy reacted to Pug957's post in the thread What did you do with your Range Rover today with Haha Haha.
    Cross thread it, nature's loctite.
    Monday at 17:57
  • Mark Piercy
    Mark Piercy reacted to Datatek's post in the thread P38A EAS question with Like Like.
    There are 3 NRV's. If one is bad, best do all 3 IMO. More likely to be the diaphragm I would think. A new dryer is not that expensive.
    Monday at 17:57
  • Mark Piercy
    Mark Piercy reacted to Pug957's post in the thread Other OKA with Like Like.
    My mate has a couple of disco 6x4s or 6x6s, can't remember which. They do look cool and would make wicked compact campers.
    Monday at 16:55
  • Mark Piercy
    Mark Piercy reacted to Datatek's post in the thread P38A EAS question with Like Like.
    Balloon over the exhaust will tell you if the NRV and/or the diaphragm are leaking Have you checked for white powder in the exhaust?
    Monday at 16:55
  • Mark Piercy
    Mark Piercy replied to the thread What did you do with your Range Rover today.
    Loctite the bugger in🤔
    Monday at 16:54
  • Mark Piercy
    Mark Piercy replied to the thread P38A EAS question.
    Pull the exhaust filter from the block and put your finger over it. Make sure a door is open so the system is isolated. Hold your finger for a while and monitor any air loss👍
    Monday at 16:53
  • Mark Piercy
    Mark Piercy reacted to brianp38dse's post in the thread l 322 cut out wont turn over with Like Like.
    Change the earth strap then you have a know good one as they rot where you can not see they are a common fault, located passenger side engine mount area.
    Monday at 10:06
  • Mark Piercy
    Mark Piercy replied to the thread l 322 cut out wont turn over.
    Try a jump lead from the negative battery post to engine and supply a direct earth. If you can have the starter checked over to rule it out. 🤔
    Monday at 07:47
  • Mark Piercy
    Mark Piercy replied to the thread Other OKA.
    Good old mechanical unimog👌
    Monday at 07:42
  • Mark Piercy
    Mark Piercy reacted to Pug957's post in the thread Other OKA with Like Like.
    Oooohhhhh I'd love to have something like that. Always been a fan on non-mainstream.
    Monday at 07:42
  • Mark Piercy
    Mark Piercy reacted to BDC's post in the thread P38 dse engine disabled with Like Like.
    Yes you should put the ignition to off for comms with becm. It doesn’t work with ignition on.
    Sunday at 12:16
  • Mark Piercy
    Mark Piercy reacted to Datatek's post in the thread P38 2.5d with Like Like.
    Low battery volts causes all sorts of problems. Put a fully charged high capacity battery on it and see what you have.
    Sunday at 10:41
  • Mark Piercy
    Mark Piercy reacted to ovalandrover's post in the thread Other OKA with Love Love.
    This mourning i went for a walk and sw a vehicle that i havnt heard of for sometime and thought some people might be intrested in .It was in camper form and looks the buisness for serious off road travel. Its an OKA and built in Australia...
    Sunday at 10:40
  • Mark Piercy
    Mark Piercy reacted to Rubberknees's post in the thread What did you do with your Range Rover today with Haha Haha.
    Nah it rained 😁
    Sunday at 10:38
  • Mark Piercy
    Mark Piercy reacted to RangeRoller dt's post in the thread What did you do with your Range Rover today with Haha Haha.
    Youve washed it 😱
    Sunday at 10:38
  • Mark Piercy
    Mark Piercy reacted to Rubberknees's post in the thread What did you do with your Range Rover today with Like Like.
    Don't know and going away on holiday first thing in morning s can't check til I come back. I don't like driving with tyres that aren't right. have had 1 blow on motorway and that was once too many
    Sunday at 10:38
Show older items