Hi, The RR is a 1992 3.9 auto (no cats). What symptoms should I expect to see if the Air Flow Meter (MAF) has failed? The reason I ask is that I unplugged it the other day while it was running and it didn't seem to make any difference. Ran exactly the same plugged or unplugged. It has always...

I had a feeling that would be the case - joys of Rover ownership I guess :) Thanks for all your help on this one guys. Much appreciated.

Im in North Wales. If the pressure is low what needs to be done to fix the problem?

How can I check the pressure?

Another update. I have now replaced the governor and the three square section o-ring seals and re-assembled the gearbox. I have also changed the gearbox filter and ATF again. Unfortunately the gearbox is performing in exactly the same way as before - changing up much later than expected in...

Another thing that I have noticed is the output shaft from the gearbox has quite a bit of lateral play. It is tight in the seal but can be moved slightly in all directions, is this normal?

Do you know a good place to buy the relevant parts?

Right, I finally got around to pulling the transfer box off the gearbox and have stripped the governor off. The first thing to note was the ATF in the transfer box was black. Am I right in thinking the transfer box and main gearbox are an open system and share the same ATF? I have changed the...

Hello folks. The heater fan was only working on III when I bought my 1992 range rover. Recently the fan stopped working completely. I assumed the resistor has failed so I've replaced it but the fan still doesn't work. Hope it's not the blower motor that's failed - not a nice job! I've checked...

I did try tightening the kickdown cable, it seemed to make the changes occur even later. I then adjusted it back to about 1 mm from the cable stop.

Finally got around to changing the oil and filter. It has improved it slightly and the box generally feels more positive but it still changes up a lot later than I would expect. I had a look at the kick down cable and it all looked good and seemed to be working as expected. I mentioned the...

Thanks for all the responses guys, will let you know how I get on.

I did, held it in every gear for a few seconds before checking it.

Thanks for all the replies guys. I checked the oil level when cold this morning. It is reading about 2 inches above the maximum mark!! :eek: I will drop a few litres out of it on the weekend - and won't use it in the meantime. Thankfully I haven't used it much, hope the previous owner hadn't...

Think they are 235/70/16 - will double check in the morning.