18 outside 27 inside on the 2nd floor of 4 floor house. The gradient is that steep 3rd floor is the garden level and ground level is 2 levels down in a square building.

Thank you ! I need to prépare mine for a salty winter. I live at 1000m altitude and they salt 5months of the year. Desperately need to get mine sorted while its dry. I like the look of the bilt hamber products. Im undecided but was looking at...

Also the factory VIN is a series of small dots which make up the letters and numbers.

If the VIN number is in the same place as mine its to left of the fuel filter on drivers side rear chassis leg. Kind of 8 o'clock from the fuel filter and a bit below in line with bottom of the filter. Mine was not visible at all I got in there...

2000 is 4 years older than mine. So will probably be in a similar condition with pretty bad surface corrosion!? The problem is the VIN on the chassis was marked/ punched not very deep at all. Apparently its a common issue. In England its not...

You probably would be getting the VIN re-punched on the rear chassis leg aswell 😅

I did read that post and couldnt really make sense of it. I think they are talking about to Zenon lights !? I think mine are just halogen ??

Thanks alot for the help, I'm English and I speak French. I will contact him, Thanks again I really appreciate that thank you ! I have been at it for a couple of hours.

Thanks alot for the help, I'm English and I speak French. I will contact him, Thanks again !

Yes they are the facelift headlights. I did have a look through the owner's manual and searching through I couldnt find anything about the lever. Tomorrow I will take one off. Annoyingly I dont have the 6 point e 10 socket.

The only way I suppose to know for sure is take out the headlamp tomorrow and look for this lever.

Im near Grenoble in France. Would it be possible to ask the guy please if the has anything suitable for a D2 and If not would he anything that could work? Really appreciate the help and response, thanks !

Ok thanks for the reply a freind in England just sent me this info; Manual Adjustment: Locate the lever: On many Discovery 2 models, there's a lever inside the headlight assembly, often on the right side of the projector module, that controls...

Could I convert RHD headlamp to LHD rather than purchasing two new lamps? Is there a cheaper headlight that will fit and work with D2 other than the OEM model for the year? They are so expensive !

It was my first thought to do that, only after talking to this 3 hour guy he put me off saying if I do it myself I run the risk of problems with it passing/ and or the police. When he said 3 hrs i thought are you sure mate..? Half the VIN is...

Hi Dave, Would you mind sharing the name and location of the garage please. Im waiting for a quote and the only guy who said he would do it, said three hours work to punch a new VIN on the chassis.. which is definately going to cost more than 30...

I have read you can switch beam direction on some lights with a lever inside the headlamp, do you know if its possible on 2004 Discovery 2 ? Thanks

the guy said he can stamp it Yeh. Not over where the old VIN was but above is fine. And with the invoice it wont fail the French contrôle technique because of that. Tempted to drive the 1000km back to England and sell it 🤣

So with not alot to loose I went out armed with a chisel and 80grit sand paper and I found the VIN or Whats left of it. Only the last three digits are visible after rubbing down. Maybe I need to persist for the rest but looks to nothing left...

This image is from another post on the forum (not mine) my chassis looks like the areas not rubbed down. Im wondering should/could I do the same?

If I scrape/sand the area with the Vin can I do any damage is it worth a shot? Or do I pay the local garage to repunch the VIN. The guy said 3 hours to strip it back punch the numbers and protect the area. He didnt say the hourly rate, I didnt...

Hi new Im new to the forum ! Also Land rovers.. I have always wanted a Land rover and just before moving from England to France a few weeks ago I purchased a 2004 disco 2. I live quite high and in the winter we get ice and snow and ofcourse salt...