Well, I tried the connector block with the multimeter and all shows well/ Then I put the light back on and the low beam failed; I then tried linking the lights terminals swapped over and back again and all's well. This shws the light is OK, but when J checked the connector and connected the...

Excellent idea. Try that today.

Almost £400 at the time, but it's a 94 total rebuild and it's my hobby,

If that's the case, it's working correctly, but swapping to mu previous Crystal light was still the same, with no low beam. Thanks, but does help.

Thanks, but does the power at beam posit0n run main and dipped beams?

My passenger side LED headlight does not operate after 5 years of use. Switch position 2 and only driver headlight operates. Put beam on and all work. Multimeter on headlight connector shows power to one tab at position 2. Put beam on and the power switches to the other tab. Changed to standard...

I'll do that Hicap, thanks. I purchased the drl's pre-assembled to the stainless bumper, and they worked beautifully for a year or so. When I noticed the problem it was just the passenger front and passenger drl affected. It then spread to the rear passenger side light, and then to the...

Well I purchased a new switch but without success. I'm now going to totally disconnect the drl's as to lower the voltage to 5 Volts seems odd and may be a faulty wire creating higher resistance, through the light cable used for lights. Is this a good idea, or am I plucking at straws?

Thanks Milktdish, but could it just affect the passenger side???

I need help with my side lights and bumper DRLS. I fitted stainless bumper with twin DRL's about a year ago, then about a month ago I noticed in a shop window that the passenger side DRL was not lit. I got out and checked when I reached work and found that the front passenger sidelight was out...

I've got three Defenders and like J said, "why not". The Defender I'm doing it to has had everything upgraded from a galv chassis, to a full leather interior. A 300 TDi beaut, and the tropical windows are the final detail.

Thanks for the Masai details.

Has anyone cut land rover roof to take alpine windows? If yes, is it best to use a small disc cutter, or a jigsaw?

Well, just to thank all who replied, as enlarging the door pillar slots to allow the latch / slam plate to be closer to the door worked. I gradually ground the slots using edge grinding drills until the second click of the lock could be heard and the door still shut to its normal position. I...

Yes, I tried that the weekend and it still opens when locked, so the holes for the latch plate will be extended slightly to get the two clicks from the lock, Thanks for that reply