hi mate I’ve got a l322 td6 I was using a snapon solus that does most of the diagnostics but had trouble calibrating suspension had to get a member from the forum with foxwell To do the suspension

The wind was probably blowing in the wrong direction @backinblack Thanks again

I would like to thank backinblack for helping me out tonight !! Brilliant fella very helpful and he even managed to sort out the suspension problem while he was here !!! Thank you mate very much appreciated

I got up early today and changed the valve block under the driver side sill and .... Still the same

Sorry everyone I’ve not been too well so haven’t been able to do anything else with it I’ve been offered a 2nd hand valve block that I might try to fit tomorrow but I’ve got a feeling that it won’t work But I’ll post here the results

Sorry for the late reply I haven’t been too good the last few weeks If you could that would be great If you Em me I’ll send you my address thanks

Just around the corner from the airport mate I can see the tower from my house

If I recalibrate it goes straight back up No faults when scanned with solus I bought it private so I’m on my own regarding warranty etc

Hi I tried that yesterday (letting air off ) Started engine and it went straight back up So let it off again pressed the button to lock suspension was ok until I drove it got to 20mph and straight back up again

:):):) Thank you everyone for the replies!! I’m thinking that the centre valve block may be the problem as I understand the air is not being returned to the tank but instead being forced into the front airbags by either a defective solenoid or crack internally allowing air to pass !? as I’m...

Hi yes it’s the same with both old and new sensors although the old passenger side sensor was seized up so would have been giving inaccurate readings anyway I’m going to try and find the cone thing tomorrow morning as kds said and check it for blockages Thanks for your reply

Thanks I haven’t got a clue But it’s been parked up for a week now as it is totally undriveable suspension hasn’t changed at all at least I know there’s no leaks !!!

Hi thanks for your comments No it won’t move with either just locked at full height

Thanks for your reply I was told by a “mate” that the sensors would be the likely cause so like an idiot I bought 2 new genuine sensors and changed them but no different, I can raise and lower the rear as normal using the switch inside the car but the front just will not go down either while...