yep they should be SFP000260 but LR Series say they could also be the following numbers: S/S STC2952 S/S RTC5574 S/S STC1275 S/S SFP000140 S/S RTC5574 I fit either EBC Green stuff pads or genuine myself, EBC are about £30 or try keeping an eye out on ebay for cheap genuine ones. You are wise...

Yep a 5 tonne bottle jack is ideal for changing flat tyres out and about but the Sealey 3 tonne trolley jacks are the best for the garage, really stable and dont stuggle like hell to lift the weight like the small 2 tonne ones do.

To bleed to the brakes you should start with the corner the furthest away from the master cylinder and work your way closer to it. Do all four corners and keep going until you have new fluid comming out as if its been in there a while it will probably be due for a change! As for your brakes...

Yep you need to replace both swivels (about £70 each) and the seals but make sure you buy genuine seals as pattern part ones wear out within a year!!

Its also worth getting a 1/2" bi hex socket as this is slightly smaller incase the head is rusted or worn a bit.

How many miles has the 200tdi done and what are you looking for for the 200tdi turbo?

Would it be possible to take the steering guard apart and oval the holes in the front plate allowing you to move the brackets either inwards or outwards to miss the bumper?

If you have replaced them in the past with the £1.99 pattern part ones then that will be your problem! I did this and now all my lenses need to be pryed off with a small screwdriver all the way around as the lense and the rubber must bond together and it leaves them looking a mess. I would buy...

Personally I use a gasket and a thin smear of Hylomar Universal when i dont want to take it off all the time. Or if I dont have a gasket I use a thicker layer. Its not eaten by petrol and stuff like that unlike the instant gasket on the fuel sender :frusty: its also non setting so it seals...

Yup that is just about beyond repair. Time to give Richards Chassis a call I think!

Could also be a loose wheel bearing allowing the disk to wobble

There is our club up in Abderdeenshire www.bordc.net we do monthly RTVs and then 4 orienteering type events per year with other social events now and again. If thats too far north then you have the Tay club at Dundee and also the Edzell club a little bit further north.

just go to your local motor factors and buy a length of brake pipe, a bag of various fittings (should be metric but you never know) and a pipe flaring tool. Have a play around and get used to it and then make up your new pipes!

First tip is to but genuine repair kits! They make a world of difference. You need to make sure the step is very very clean, scrape it out with a wood chisel or a knife or something. The way I do them now is not the recommened way but it works for me. I split the caliper in two and then use a...

The transfer box mounts should all be the same so your propshafts should be ok. I have a 3.9v8 coupled with an LT85 box and LT230 transferbox in my 90 and it works well offroad.